How to Replace Front Engine Mount 03-12 Volvo XC90

Buy Now!

1A Auto shows you how to remove, install, change or replace a broken, worn out motor mount. This video is applicable to the 03, 04, 05, 06, 07, 08, 09, 10, 11, 12, Volvo XC90.

This process should be similar on the following vehicles:
2003 Volvo XC90
2004 Volvo XC90
2005 Volvo XC90
2006 Volvo XC90
2007 Volvo XC90
2008 Volvo XC90
2009 Volvo XC90
2010 Volvo XC90
2011 Volvo XC90
2012 Volvo XC90
2013 Volvo XC90
2014 Volvo XC90

🔧 List of tools used:
• 18mm Wrench

Check out our playlist:

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[AAuto]

√ *Watch the Video*
√ *Do it Yourself*
√ *Save Money*

[elguapotube]

Great video, very helpful. With my 2004 XC70 I had to remove the passenger side mount too in order to jack the engine up high enough.

[localflavor]

The airbox hose on the 2007 up is mounted differently from the '06 and below models

[legambaz]

What about the mount for the rear? I was all excited when you said you're replacing those rounded mounts. There're 2 of them. Thought you were going to do it for front and back.

[eddiewouldgo]

Nice work! Couple quick questions. Do you also need to loosen the passenger side mount(wheel well area under timing belt) so that it doesn't stress when engine is raised and is that 14 mm bottom bolt holding the mount reusable or should it be replaced?

[ArifRahman-qviu]

Hello team,
I have a 2007 Volvo XC90 3.2 auto petrol . It’s been few months now I hear a dragging tatatata continuous noise WHEN I start to accelerate, any ideas please will be appreciated?? Many thanks in advance!!

[jolo-bolo]

Yes right no mention of the vacuum line that go into the original ones you have to take off. And then put back on by being double jointed or hanging upside down in the engine bay.

[ighostkasper]

Hi. What is the mount replacement interval?+-

[DLindgren]

I would have liked to se you take away the plastic box ontop of the front engine mount. didnt see you connect the vacuum hose either?

[hankgoodman]

Do the mounts contains fluid, there's some type of oil under it?

[shangenginemount]

Hello friend, I am a factory that produces engine mount. We specialize in Toyota and Honda series. Is there any chance I can cooperate with you?

[winterbrotherz]

Does anyone know if it’s the same on the V8 XC90?? I’m working on getting the old mount and it seems much different

[axinnm]

Does the car need to be on a lift in order to replace all motor mounts?

[oyetim]

Thanks bro, volvo ain't practical with convenience of replacement in a lot of their designs.