How to Replace Engine Mount 2006-2013 Chevy Impala

Buy Now!

This video shows you how to install a new engine mount on your 2006-2013 Chevy Impala. A shaking or vibrating engine, or bucking when changing gears are signs of worn engine mounts.

This process should be similar on the following vehicles:
2006 Chevrolet Impala
2007 Chevrolet Impala
2008 Chevrolet Impala
2009 Chevrolet Impala
2010 Chevrolet Impala
2011 Chevrolet Impala
2012 Chevrolet Impala
2013 Chevrolet Impala

Tools you will need:
• Socket Driver
• Swivel
• Block of Wood

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[casdoitall]

I just changed out my mom's engine and trans mount. All thanks to you guy's videos.

[casdoitall]

Excellent video, I didn't know Bob Ross was also a mechanic!😂😂

[ezwa]

so since all these motors transmissions etc. are differant, what year, type, size was that 1?🤔

[adriannavarro]

I replaced all mounts on my 2010 Impala, but it seems to kick/jerk when i shift from parking to reverse, at times it kicks pretty hard, anyone knows what it could be?
A transmission solenoid maybe?

[tsfyootwiin]

Just ordered mimes today, can't wait to fix it on my 2010 Impala

[brianszanyi]

I just did the job I did it from the I took the passenger tire off I would suggest that you cut away the bad rubber with a steak knife so you can use your socket better cut away the bad

[JimTMcDaniels]

I say wrap-cover that new mount, before installing, in some discarded durable plastic bag/packaging and use some clear box tape to secure around it.
This way, petroleum oils which leak out of the seals of our old engines won’t be able to drip on and degrade the edpm rubber mount, causing another failure!

Take care

[RCLBWD]

Bro you gotta show us where the bolt is at, you got the camera zoomed in so far you can’t tell where it is

[barrysauce]

If these bolts are not properly tightened would it cause vibrations during hard acceleration and also make the engine not run as smooth?

[nurxwik]

Do you have to loosen the upper motor mount to raise the motor to replace the hydraulic motor mount

[drjoeset]

Never tighten bolts until all bolts are in place, it makes life a lot easier, Now as far as the nuts on the bracket you have no choice because you won't be able to reach them later

[capadon]

How many lower engine are on this vehicle?

[cecilwebb]

Poor camera angles on this 1. Couldn't tell what you were doing and where.

[doc_ineeda_win]

did you have to losen or take of top mount to let it lift enough?

[xx_tyrome_xx]

If your not a mechanic already you have a tough time this video