How to Replace Front Knuckle Assemblies 2013-2017 Honda Accord

Buy Now!

This video shows you how to install new front knuckle assemblies from TRQ on your 2013-2017 Honda Accord.

This process should be similar on the following vehicles:
2013 Honda Accord
2014 Honda Accord
2015 Honda Accord
2016 Honda Accord
2017 Honda Accord

Tools you will need:
• Pliers
• Wire Cutters
• Cotter Pin
• Small Hook
• Wheel Chocks

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[davidhamilton]

If you have a bad front wheel bearing...just do this....JUST DO THIS! This is soooo much easier than trying to save money by just doing the bearing...don't ask me, but I know...

[cohlroxkim]

broke one lug stud on the front and now I think I am going to have to do this because honda designed their 9th gen accords to not being able to replace one fuggin' lug stud on the front because there isnt enough clearance on the kunckle. The rear ones come out easy but not on the front.

[shmellyhandsprod]

Can you tell me if a 2017 accord sport knuckle will bolt up to the strut of the 2015 accord sport

[bmlb]

TIP: Watch out for the inner boot of the CV Axle. If it slides out and comes out of place you WILL NOT be able to get the lower ball joints into control arms.

I'm sure i will be editing this post with other tips as i think of them!

[MrEfoozz]

@3:00 spray wd40 or rust blaster on abs sensor and it will slide off (no need for a new sensor)

[StrRazor]

Customer: Replace the knuckle but keep the rusted calipers..😂

[nathanhovey]

Never again, major BS how you guys make it look so easy, it is not an easy job, every bolt you try to remove is stuck and seized, struggle for three hours alone trying to get the CV axle out of the knuckle. ATTENTION!!! If you're going to do the job, go ahead and order new abs sensors and sway bar links, the sensors are not going to come out of the knuckle with out breaking and the nuts of the link are just going to spin, you can tru to put a locking plyers on the back side of the link bolts but they are just going to spin spin spin, never again am i going to attempt this job, my knees and back are going to be sore tomorrow FML