How to replace Driver Side Suspension Knuckle Kit 2008-2012 Honda Accord

Показать описание

Buy Now!

This video shows you how to install a new suspension knuckle kit on your 2008-2012 Honda Accord. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.

This process should be similar on the following vehicles:
2008 Honda Accord
2009 Honda Accord
2010 Honda Accord
2011 Honda Accord
2012 Honda Accord

Tools you will need:
• Pliers

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Рекомендации по теме

Комментарии

√ Watch the Video
√ Do it Yourself
√ Save Money

TRQ

Thank you so much, I'm no mechanic but bought me tools and since then have been fixing my own car by watching this videos. They are concise and very easy to follow. Thanks to you I was able to fix it on my own. Took me a few hours. But worth learning and doing what a man is supposed to do.

donttrip

This video was efin awesome! I have 0 mechanical experience and I followed this to the tee and was able to successfully change both front wheel bearings. The noise is completely gone and I gained a ton of experience running this project. I can’t thank you guys enough for sharing such thorough instructions on how to do this.

jamesyepez

Thankful I found this. Why worry about pressing out a bearing when you can mess with a few bolts?

bdream

Great video. These loaded knuckles are the way to go, especially for those without a press.
Those damn bleeder screws always seem to snap, so I try not mess with them, unless I'm bleeding brakes. Just take the cap off the fluid reservoir and push the piston in, that way any air can escape and you don't have to worry about bleeder screws.

RTRRV

Keep your original Lower Ball Joint Star Nut. The one that came on my suspension knuckle from 1A Auto stripped before it reached 60 ft lbs. of torque. I reused the old star nut just fine. I am very happy with this purchase and the video made it very easy. The grinding noise from my bad wheel bearing is gone. Thanks!

cdeman

Do you need an alignment if you follow every ste you just showed here?

dnznznfjsnsnsms

The bolt on my upper control arm ball joint spins with the nut when I try tighten it! Any tips??

helenlelidis

Hello TRQ, Was watching your posting 'How to replace Driver Side Suspension Knuckle Kit 2008-2012 Honda Accord' as i am ready to replace my 2007 Accord front driver side steering knuckle. In your video, when putting back the lower control arm, the castle nut and the carter pin were not aligned. in other words, the carter pin did not go in-between castle nut walls. Wondering if this is ok to not align? Please advise.

ksakshm