3 Ways to CORRECTLY Splice Electrical Wires

This video tutorial shows 3 methods of splicing electrical wires. It warns against the incorrect and dangerous method commonly practiced. The first correct method is splicing wires without the benefit of a connector. The next two methods use 2 different families of connectors, namely the twist nut and lever nut. These methods guarantee reliable and safe connections.

[pauljanssen]

Your second part was correct but very messy and you need to solder! the wires might as well use some shrink tubing while you're at it!!!

[TomStedham]

I watched this today, and then re-wired a cord for the first time. Thanks for the helpful instructions~!

[nickcavanaugh]

with the first method your splices need to be 6 inches apart to prevent them arching if tape is compromised

[isa]

Im in oregon, where can i get full wires for my burner pan. Ive replaced the burner switches and they dont last very long even with the heat rap. This time i use your hook wire method.

[emmandoriao]

Thank you for this video! I have the connectors, and when I cut the casing from the wires, some of the copper strands get cut off. How do I get it so that all of the wires are in tact?

[kenjipattiinugai]

who sells these lever connectors? the major stores don't even carry them online

[martinrubin]

any need to match the wire ends of wire you're adding to the first set in the lever exp?

[anthonyminchinton]

All of these methods are illegal within the United Kingdom. Flexible cables must be contained within a fireproof container with cord grips to secure the flexible cables and requires a tool to open the fireproof container, unless within an approved electrical trunking system. Terminals are required to electrically join conductive cables. Please note PVC insulating tape is only meant to be a temporary method during installation, not permanent. The glue will degrade over time and become loose and fall off. This entire video is very bad advice leading to fires and electrocution, which is why it is illegal.

[Itoons_]

My wires are hard and strong copper not brushy like yours

[warsopstebbing]

This is so dangerous. Don't do the twisting method like this unless you are in an emergency situation