Full MikroTik MTCNA - Initial Manual Configuration

Hello and welcome to this tutorial! We will be going over how to configure a WAN-DHCP Client for internet access. How to setup a LAN IP address on an interface for hosts to connect to as well as a brief look Masquerading using NAT. This is a fun environment showing in real time what the effects are as each part of the configuration is added. Hope you enjoy!

Support the Channel:

Social Media:

EVE-NG Setup:

Timestamps:

00:00 - Introduction
01:42 - WAN-DHCP Client
03:26 - IP Addressing
07:08 - NAT Masquerade
09:15 - Default Gateway (Route)

Credits:

Thumbnail: Created on Canva

Thanks again for watching

[RedWollip]

Your videos are always impressive to say the least. Thank you for the quality presitentation and education.

[mpdroza]

Thank you so very much for explaining so well and consisted. I have been difficulties setting my Mikrotik until now

[AmitRoy-krkg]

hi
am just trying to configure mikrotik hex router in wireless option but there is no WLAN showing icon on interface option ..how to i install it

[mooll]

Please can you tell me what good books to read about MikroTik RouterOS?

[mfarokh]

For masquerade, I generally do srcnat and type the network address that I want to allow to connect to internet into the "src address" and don't choose out port at all. Is this approach okay?

[duduloi]

I saw this type of habit a lot and I consider it a mistake, no offence.

You jumped into the settings and connect a blank router to the internet. No no....

First you need to make a new admin user and disable the default admin account. Then to set some basic firewall rules. Only after you can connect the router to the internet, set a DHCP server etc.

Internet is a dangerous place. Any new device connected to the internet is scanned/attacked in less than 5-10 minutes. You need to avoid that.