Perfect PETG parts on Bambu Labs printers - Hands down!

[teomilos]

Wow nice PETG tip. Good to see that isopropyl alcohol bed clean at the end

[yerry_verse]

you can also try the textured bed, I'm like you... I refuse to use glue.

[happytrails]

having no issues with textured pei plate and petg works very good. going to order a little petg hf to see how it is. they say its really good too.

[SmokeEater]

Check out the Rexall Isopropyl Alcohol in the spray can. Goes on as a fine mist and cuts down on having to mess with spray bottles.

[laszloszell]

Usually the problem that the users don't wait till cool down the part and bed. They just want to remove after minutes

[juliusfucik]

I have printed PETG on any type of bed. I never cleaned any bed. Never had any problems with adhesion. Just heat the bed to 80 degrees and print a little hotter. The nicest prints I get on glass.

[willvolovich]

I also hate glue, but people do say that specifically with the wham bam sheet you ARE supposed to use something like glue when printing PETG

[sotErik]

I made this mistake using TPU to make a gasket. It ripped the PEI coating off of the spring steel. Now I use glue stick just so I can soak it in water and have it release, but I get why people wouldn't want to do that.

[tombo]

NICE! Subscribed. New to Bambu Labs myself, on all the old bed slingers, we always used AquaNet and it is awesome each time, and you add a lil back on after each print, and it like.. revitalizes the surface. So nuts but true. Even rebuilt bed strikes from nozzles with the AquaNet.. the more you know.

[JonLaRue]

I like how wham bam tells you to use glue stick with PETG, and Bambu says not to use isopropyl alcohol on build plates and not to use cardboard spools in the AMS....

[stevemiller]

Use the PEI plate, prints perfect every time

[thecamarokid]

Did you follow wham bams instructions before use?

[electro]

I only use 3d lac only every 10-20 prints just sprayes on like hairspray and is removed by washing it. I have washed my plate 2 times until today xd

[rysstone]

Is it okay to Print PETG direct on the textured PEI plate wich came with the BBL X1C?

[PanCyan]

Whats your beef with gluestick? Or using interference layers ? I do not understand why.

[oneheadlight]

Any textured PEI sheet will work great with PETG

[djencode]

Your ams is going to jam up from cardboard dust. Need to print edges for those spools.

[misfinEM]

Can you please share your BambuLab settings for Polymaker PolyLite PETG? I have an X1C and I just can't get it work. Allways really bad surfaces, I even tryied to use PETG as a top surface support material, but will not stick to PLA enough, I cant use this PETG no matter how well I try to calibrate it. I had flaweless results with all other filaments like PLA, PA6-CF/GF, TPU but this stupid PETG killing my nerves.

[maxeriousbrooks]

I was gonna comment petg is so easy to print so I don't understand the struggle then reading the comments it might be due to the fact my printer came with a pei textured bed petg sticks and releases just fine

[cheizaguirre]

I print PLA, Do you have to change any settings to print PETG? If so can you explain it please 🙏🏼🙏🏼🙏🏼🙌🏼