Building My Dream Yacht From Scratch Pt 15 - BBQ AND FRIDGE!!

Music:
Fareoh - Cloud Ten

[Cal-]

Another idea for the grill area. You could have another door that flips down the length in front of the controls.

[yorgle]

You may want to look into getting an RV fridge. They've got a latch to keep it from opening during transit, and usually run on 110v, 12v or propane...

[Chris-yigf]

You may as well get two more sets of those doors and put them under the grills for extra storage room.

[Beardest_Fishing]

If those grill knobs are held in with set screws you could easily build a small extension and put the knobs on the outside of your handmade box and I’d guess the trim rings with the writing could bolt on the outside as well.

[subbystyle]

Chris, why not make the front of the grill box where the knobs are a flip down? Use when in use and close when in storage!

[adamlowe]

Vents on the back behind engines, to help flow thru of all that stuff 🤪

[Nwithaskillet]

I was expecting an inflatable BBQ for a second.

[bwfvc]

A consideration is to not condense fuel fumes onto/into food surfaces or food in storage.

[joshuatycer]

Trim out the edges with flat metal. Need a little space for metal movements due to weather.

[dcrahn]

Even though the engine boxes are open at the bottom, you might want to consider installing a couple of bilge blowers. The Coast Guard and Insurance may even require it for that type of engine cover.

[Jmoniz]

U should add rubber caps to the tops of the square tubing it’ll one stop water from going in them and two give the grill/ice lids a rubber surface to sit on so as to not rattle or bang if dropped

[dreadpirateCarlos]

Dude all these sharp corners and thin aluminum edges are going to make for a real safe boat. Ouch!

[mikejulien]

Ummm… feel like a meal prep area where you might have raw meat juice should not drain into the ice where you have drinks chilling… think changing the angle to have 2 drains may be a less ecoli-y design

We're going to need a bigger fridge

[tiCln]

For the ice section you could find a solid plastic tub and cut a hole in a alum sheet so the tub sits in. lay the sheet horizontal over the current ice area and put tub in a big plastic bag sit in back into place and fill gap with expanding spray foam. once set remove tub from bag now the inner liner can lift out to empty and clean and be insulated when in use.

[wascott]

In your Ice bin you could use your foam board on the bottom and sides then use a NON thermo-conductive waterproof membrane to seal it ... don't forget the lid so the sun doesn't cook your Ice.

[tigerbaas]

Wrap it in a light color. Black will absorb soooo much heat.

[rockdaddio]

Very cool man. Remember 25 people equals 10 cases of beer. Vent the hell out of that propane storage area. make a Styrofoam liner 1 inch thick around your cooler – sink area and don’t worry about it losing ice, because people are gonna drink it fast.

[eamonmatthews]

Put a second hinge on the face so you can get to the knobs on the grill

[TheRoulette]

drill hones in face of box ... remove knobs and bezels from grills, slide grills forward till valve posts are through said holes ... put bezels and knobs knob on .... but outside big box.... boom