How to replace Torque Strut Engine Mount 2002-06 Toyota Camry

Buy Now!

The torque strut engine mount braces the engine against twisting, shaking, and vibrating when under load, and when load changes suddenly. The rubber bushings on the torque strut mount will wear down over time, and need to be replaced, even if the strut itself is in good condition. You'll know it's time to replace the torque strut engine mount when you feel vibration or shaking, especially when accelerating. This video shows you how to install a new torque strut engine mount on your 2002-06 Toyota Camry.

This process should be similar on the following vehicles:
2002 Toyota Camry
2003 Toyota Camry
2004 Toyota Camry
2005 Toyota Camry
2006 Toyota Camry

Tools you will need:
• Drill

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ *Watch the Video*
√ *Do it Yourself*
√ *Save Money*

[Digitalsurfer]

I bought a 2002 Camry basically the same month you guys put out all of the videos on this generation of Camry, and they have come in handy many times in the last year!😅

[ZahidKhan-httw]

do you have to support the engine when replacing the mount?

[kurtwagner]

Taking the bracket off is easier than trying to wrestle a new, tighter, strut into their mounts. Otherwise it can be very tight and difficult to line ip the bolts. At least that's how it went for me tonight. Good video, thanks!

[MVPURDYSZN]

Do you need to support the motor when switching this out or is it fine.

[anbazmi]

Excellent video. Short and to the point!

[HereWeGoSteelers]

What size socket are you using to remove the bolts in this engine mount? Thanks

[stevedyer]

My rubber washers are in bad shape, as shown at 0:43 in video

What is the part number for these washers and where can I buy them? THANKS!

[curtcritt]

Gosh I love you all. Is the drivers side the same though and are there mounts on the bottom of the engine as well? @TRQ because I was just quoted $800 to have this done and my feelings are kinda hurt now

[moutaim]

How tight should I do it if I can't torque it?