Scenario Based Interview Question For Network Engineer.

Hello, Welcome to PM Networking...
My name is Praphul Mishra. I am a Network Engineer by profession and a Certified trainer by passion.

About this video:-

Scenario-Based Interview Question For Network Engineer.

CCNA Configuration Playlist:-

CCNA Topics Wise Lecture:-

Interview Questions and Answers:-

Cisco Basic Configuration:-

BGP Series:-

Our Social links:-
Whatsapp:- 8511826341

#ccna​​​​ #ccna2021​​​​ #newccna​​​​ #ciscocertification​​​​ #computernetworking​​​​#cisconetworking​​​​ #ccnaroutingandswitching​​​​ #ccna200301​​​​ #networkengineer​​​​
#telecom​​​​ #ccna​​​​ #routingandswitching​​​​ #pmnetworking #ccna_exam #computernetwork #computernetworking #ccnanetworkengineer #Networkengineer #WhatisCCNACourse #ccnaFullCourse #ccnaCertification #ccnaexam #cisco #ccnaSyllabus #whatisccna #ccnakyahai #ccnasallary #ccnasecurity #networksecurity #ciscorouters #ciscoswitch #ccna_salary_package_in_india #ccna200

[martinmukema]

For Layer2 or intervlan
-We need our switchports to be access ports.
-We also need a management ip configuration eg int vlan 10
-Our switchports should us management ip as gateway
-ip routing should be enabled

For layer 3
-Our switchports should not be access switchports we use no switchport command here.
-ip address will directly be configured on these switchports
-enable ip routing.
-we might also need a routing protocol ie default route.

[ankitprajapti]

When the same vlan nodes are try to connect each other the switch perform L2 Switching but when the one vlan node try to connect with different vlan node then the switch perform Ip routing (L3 Switching)

[omprakashpatidar]

For layer 2 switching, we need to configured as access port for interfaces.
For layer 3, we need to enable routing through ip routing command to perform ip routing function.

[manjunathm]

First we need to enable the IP routing. Once Routing service started, It will see ip address & do L3 function.

If Destination IP and source IP address present in the same subnet then switch will do L2 job.

If Destination IP and source IP address present in the differnet subnet then switch will do L3 job.