TRONXY X3 First Print

Didn't want to wait any longer so printed a Benchy I sliced for another printer. Needed more retraction, but not bad for first print.

[KifDawg]

Hopefully you reply to this, but i just bought a tronxy x3 and i am having trouble finding the machine settings for it, it tends to print off the bed and is driving me nuts

[idigd]

Couple of issues. Model was sliced for another printer that didn't have a Bowden setup.Not bad for no parts fan. But, I just found out that the hot end fan cools the heating element too much that it won't heat over 210ºC. Wanted to attempt some ABScent™ filament from 3DXTech but not hot enough. I'll have a better review with pics on my site www.idig3d.com soon. Designing a parts fan so I can get better PLA prints, and divert the airflow away from the hot end of the cold zone fan for ABS and higher temp plastics.

No noticeable ringing. Mostly pleased so far, but definitely first version. They need to double-check parts lists, provide wire routing instructions. Better attachment security for heated bed wires. Better set up instructions fro bed living. Had to set negative values in the EEPROM (X: -15, y: -25) for the leveling auxiliary settings to work by staying in the right areas of the bed.

I added a glass bed with Aquanet--my preferred print surface.

I currently would not recommend it as a first printer unless you want to figure out lots of stuff that need fixing or clarifying. I'll try to list suggestions or fixes or ways to get it working well and minimizing failed prints.

[davidcaseiro]

Good, all right?
What is the print speed that is configured for that finishing touch?
The thickness of the filament speed, table temperature and extruder and the speed of the first layer to the following?

[racoonfox]

print on it first time only, the five next time it's print about 5mm high, then model detached from table. And after that it becomes print and no any filament attached to the table. I think, that filament feeder don't work (at first), but i marked, that some (15mm) of thread throw out of nozzle, but not printing while nozzle drawing the line. Do u know, what can i do?

[joaocaseiro]

You need some configuration for the printer to print, I'm trying to print but I can not print anything, it is necessary to remove the internet some configuration?

[joaocaseiro]

Good, I have a problem in my printer and do not know how to solve and need help a lot, I set up the whole electrical installation only not connect the panel can not even connect to the computer printer, current flows across the site of the panel and all this current with only the league not screen or connected to the computer with

Please help me I'm getting, not knowing what to do ....

[JustMeInMyPatrol]

:) have you had any z wobble issues with yours?

[goldbunny]

I don't see the point of making a video proving you're too lazy to get your settings/slicing right before wasting a load of filament. If youre going to make a vid like this at least pair it wth one where you corrected the wrong settings and show is the much improved result. It's not a requirement to accept a poor result First Print when you could aim for a brilliant one.