Tronxy X3A with auto levelling 15 minutes test print

Tronxy X3 on wiki

Tronxy X3 on Github

[richardbrown]

Just to make sure.. You have the Melzi V2.05 controller board.. with the Atmega1284P chip, Correct? And the display is Two lines with five buttons.. I just want to make sure. Thanks Richard

[silentnoise]

Hey nice video... I just got one too! Do you buy chance have any FFF Profiles or recommended settings for the gcode? I found that the auto_level_test.gcode prints great but I tried another gcode and the print was horrible. I thank you in advance for your support. Happy Printing.

[gueifaopedro]

I´m waiting for a X3a then it appears the X3S, in your opinion beside the 200x200x300 and the 300x300x400, that is a different fact, should I bye an X3a or an X3S. Thanks

[TheEvilGuy-fds]

hi how was the printing after all?
I just ordered this printer I heard a lot good things about it but just wandering how it works for you

[crywhi]

How you setup the sensor for the first time and settings on screen, please?

[davidkrayenhagen]

how would you install a leveling sensor on the Tronxy X3 not the Tronxy X3A?

[jimmassey]

Will the auto level sensor read through a glass bed
?

[abluske]

You have a link to buy that sensor or how to install it?

[peterschmidt]

What is your Firmware on your Printer ???

[TheEvilGuy-fds]

how long it took you to put it together?
any problems at all?

[dsmith]

where did you get the leveling sensor from?