Bathroom sink plumbing installation

In this DIY plumbing video, I’ll show you how to how to install a sink drain, plus how to install a vessel sink and wall faucet. This bathroom sink plumbing installation tutorial is easy to follow and will allow you to plumb a P trap and install a bathroom sink pop up drain on your own.

►SUBSCRIBE TO MY CHANNEL

►TOOLS & MATERIALS USED (affiliate links):

►ALL MY TOOLS & GEAR

►WRITTEN ARTICLE

►MERCH, APPAREL & PLANS

►Follow me on SOCIAL MEDIA

[HiddenAgendas]

Best explanation and walk-thru by far. Thank you. Most of the other videos has zero commentary, very vague, skips a few steps and droned out with loud music.

[tradz]

Big Thanks...really helped since I couldn't find the info I needed for ensure a proper seal of the drain to the sink...the original instructions only showed use of a flimsy thin rubber washer that spells leak city. I really liked the use of silicon to solve this concern.

[rachelvillatoro]

You totally rock!! You thoroughly explained it and saved my husband from agony when we were trying to figure out how to connect 2 pipes that were different in size. Thank you, my vessel sink is done 🙂

[aark]

Very clear and concise. Maybe you should offer a video about how to film instructional videos 🙂

[martytruelove]

THANK YOU for the direction and guidance...a refresher course sure helps.

[CaptKaffeine]

Nice and helpful installation video. I like how you explained the different washers, direction, and what was replaced in the p-trap kit versus P-trap adapter fitting into the wall.

[RVRayRay]

Thank you!!!! I just replaced the pop-up drain on my rv bathroom sink. It was a quick & easy job, thanks to your video.

[jean-marclariviere]

brings back a lot of memory. Good thing that you copper pipe was well anchored in that back wall. Like i said, memories....good and, not so good. Great job as always.

[brucejohnson]

I was taught (long time ago, but it was a This Old House episode where they were actually doing real people's old houses :-) that you should use plumbers putty on the underside of the drain fitting where it rests on the sink and to NOT put anything on the threads. I've not had any issues with any of the sinks I've fitted that way over the years. A little jar of it from Ace Hardware lasts forever.

[ScrewballMcAdams]

Great, easy to follow DIY video. Very helpful. Thanks!

[marthayolandadiaz]

By far the most informative and well-paced video of all the ones I watched on this topic. Thank you for sharing your knowledge!

[ejtakach]

Great install video! I like your explanations where you go back and forth to show potential hiccups in the process.

[ileanamorales]

Great visuals and above all, very clear instructions. Thank you so much 😊

[jasono]

1:25 if you apply the silicon caulking to the thread of the rubber ring, aren't you then going to smear the caulking over the threads on the tailpiece? ...and you'll end up gluing your locking nut to the tailpiece? (which would make potentially removing it in the future nearly impossible)

The tailpiece of the drain pipe that I just installed had no threads where the rubber gasket went (and thus didn't need any caulking!). It also used a special locking nut (much deeper than the one you used).

[RVILDOR]

Very clear instructions. Thank you so much

[richardbrunelle]

Great job Marie! Love the way you utilized the small space, and the vanity came out beautiful.

[woodywoods]

Great job Marie!!! you make it look so easy you must have alot of patients:-)

[lolthien]

Very basic, and exactly what I needed! Thank you!

[RobertJKeller]

Nice one! I’m saving the link to that faucet! Love it.

Hello there. Thank you for installation information of bathroom sink installation..