Full MikroTik MTCNA - QOS (Simple Queues, Bursting, Schedule, Packet Marks)

Hello and welcome! In this video we will be diving into the wonderful world of QoS on a MikroTik device. You will be learning how to configure a simple queue on a MikroTik device, how to setup schedulers and burst limits as well as adding more advanced things such as packet markings to your QoS rules.

Support the Channel:

Social Media:

MTCNA Playlist:

EVE-NG Setup:

Timestamps:

00:00 - Introduction
00:15 - QOS Theory
01:27 - Simple Queue
06:19 - QoS Schedule
08:28 - QoS Bursting
12:30 - QoS Packet Marks

Credits:

Thumbnail: Created on Canva

Thanks again for watching

[tonyalbert]

This was well put together and very informative to someone new to Mikrotik devices. Thank you!

[NervousNab]

I've created queue to prioritize cs 2 tcp packets thanks to you. Thanks :)

[eduannaude]

New to mikrotik. I learn so much from your videos. Thank you

[robertjohnston]

I watched some of your videos before obtaining my 4 mikrotik certs. The teacher I had was not as good as you. Amazing style of teaching

[Heinzeis]

Dankie vir die Videos, ek leer baie by jou. Uit Bloemfontein.

[marcinas]

thx a lot... It was my problem since many months ;)

[ap]

12:53 correct me if I am wrong, as I understand it "limit at" is not the upper limit but lower limit. It is the minimum bandwidth guaranteed to a client (as long as the pipe is not saturated).

[DimitriPappas]

Assuming the second rule was also prerouting and with the same dst-address, wouldn't it have the same effect as using forward? (at least, for qos purposes?) Forward does seem to be the more intuitive choice, but unlike the distinction with input/output/forward filter chains which was easier to grasp, I sometimes still struggle figuring out when to use prerouting vs forward/input (or even postrouting) when it comes to mangling, so I just try each one (in descending order of what seems to make the most sense) until it works, lol. Also can postrouting packets be marked for QoS or should it all be done prerouting? I'm guessing postrouting marking doesn't make sense because the packets have already been sent out to an interface..? XD

[PeerMahaar]

Hi
Could you please tell about Youtube marking rule like this busting perpos

[biki]

from what i learned 'limit at' is guaranteed bandwidth for the queue.

[meinsda]

Do you have a good script for VoIP telephonie?

[eisamohammadzadeh]

I have a dhcp that I want to limit bandwidth in mikrotik. I want to make sure that users can use all the bandwidth when they start downloading, but then, for example, they are limited to a certain speed after 10 seconds. How can I do this?

[cna_academy]

Hi dear can i used the simple queue for entire network not only client

[carlb]

Does simple queue have overhead? When I use it it deducts about 50mbps from what I set in the limit, tried different firmware but still doing the same.

[spikmahlophe]

MWEB??? Johannesburg??? Been Following your channel for the longest of time, Great Channel By the Way, and never once did i ever think that you might be right here in Johannesburg!

[tarzan-woxs]

hello sir pls let me share speedtest bypass .

[MSIZAR]

You in Johannesburg bro?? Small world !!!