Canister Purge Valve Replacement Ford Duratec 2.5L

In this video I go over the process of removing and installing the evaporative emissions canister purge valve on a Ford Duratec 2.5L. The vehicle featured in the video is a 2012 Ford Fusion equipped with a Duratec 2.5L. However, this particular Duratec 2.5L was used in other Ford models over the course of several years so the information found in this video is applicable to many other Ford models. Of course, do verify the information found in this video is applicable to whatever vehicle you are working on by using an appropriate repair manual for whatever vehicle you are working on.

Here is a link to the video showing how to diagnose a canister purge valve that is stuck open:

Discloser: As an Amazon affiliate I make a commission on qualifying sales.

DISCLAIMER
Barbour's Auto Help is not responsible for any damage or personal injury incurred in the process of performing any auto repairs done by you the viewer. Automotive repair is extremely dangerous. Repair your vehicle at your own risk. It is the viewers responsibility to verify all information and procedures as outlined in YOUR REPAIR MANUAL AND OWNERS MANUAL FOR YOUR VEHICLE. Owning and using a repair manual suited for your vehicle is essential for correctly and safely performing ANY repair to your vehicle. Always wear safety glasses, protective gloves and heed all instructions for use applicable to any piece of equipment you may use. Due to circumstances out of the control of Barbour's Auto Help, Barbour's Auto Help makes no guarantee that by the use of the information given in this video a quality repair will be made. Barbour's Auto Help makes no guarantee that the information provided is totally complete, synchronized and accurate. Verify everything using an appropriate repair manual. Verify everything with your own research.

[carnagerulez]

Recently came across your video due to mechanic shop showing bad purge valve on the diagnostic. Cost to replace was $200-$250. Watched your video, bought the part and replaced it. Made the check engine light turn off so I assumed it was done right. Now my only hiccups were that I didn’t have any oil to put on that washer. And I didn’t have any type of torque wrench. I did however tightened it to the point it was on there super super tight. With no wiggle room to move. Do you think this will be ok? I drove it and it seemed to be ok. Thanks for the great video!

[JoseLopez_]

Is the purge valve supposed to stick out a bit when I replace it?

[jamesrock]

How do u reset the computer after u change it? Or will the light go out it self?

[robertbaezgonzalez]

I replace the purge valve of my ford fusion 2013, at the beginning everything was ok until i pour gas on the tank it had a slow start any suggestions?