How to make PCB Without Iron, & Added solder mask in PCB trace

Thanks to JLC PCB for sponsor this video

you can watch this video in Hindi language,
2nd Hindi Channel (The Amidst) please #SUBSCRIBE

(previous video)

With EEPROM, Without Relay, IR 4 Channel Remote Control System . For your Room Appliances. (V.2)

components Purchase Link

Contact me (Only Sunday)
-------------------xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx----------------

[sidyajv]

This method works like charm, i have been using it for a while. Few points to note -
1. Dont use thick photo papers for this method, the thinner and lower the quality of photo paper, the better are the results.
2. Note that not all nail polish removers are acetone based. Check this when you purchase.
4. Do not pour too much acetone on the copper board, just a thin layer to conver the entire board.
5. Also, do not pour too much acetone above the paper.
6. You can apply very light pressure once the paper is sticked to the board. Applying too much pressure will spread and widen the tracks.
7. Do not immediately remove the paper once the paper is sticked. Wait for until the all the acetone has evaporated, you can feel this by touching the paper above and it will feel cold.
8. You may need to experiment for a while before you actually start getting good results.

[mavitimsah]

Thank you for this teqnique! This is exactly useful PCB producting teqnique at home!

[FantaBH]

it looks easy with very nice results at the end, I like it.

[stevenkamala]

Thanks for making this video, it was great 👍

[muhammadazamazam]

Super good 100%-I Iike it EASY and clean Thanks Alot.

[vikiTech]

Good.... really nice idea for making PCB....👍👍👍👍👍

[fredrikbergquist]

You can use Ammoniumpersulphate instead of ferrochloride. Used to make pcbs like this until five years ago, but then I discovered JLCPCB have made like 15 boards by now! I often need vias and smd ICs nowadays so professional pcbs are a must.

[fontanot]

Wow, that's really impressive, thanks for the tip

[sujitchakraborty]

its really nice, i was using ironing method, but that was so difficult and sometimes due to overheat clad board get damaged, can i use any nail polish remover ? actually nail polish remover is one kind of thinner right ?

[awaitingthetrumpetcall]

Brilliant.
You also made a 2-sided PCB by using two pins to perfectly line up the other side.

[nandeepkhajuria]

Wow thanks for your help it's very very useful

[ellisgl]

Last time I did a hand made PCB with toner, I printed on vinyl sticker material and used cheap laminator machine to do the transfer. Results were pretty darn good.

[diptangshudas]

Thanks a lot. I think I will get rid from ordering PCB and HIGH custom charge 🥵🥵

[ShawnJonesHellion]

Excellent! Not always able to learn about everything but the short videos help.

[Winterfall]

Hey, How can we print multiple layouts on a single page? just as you did without changing PCB layout size

[suryapatnaik]

After making the pcb, the ferric cloride solution is waste or can be used for next pcb??