Welding 6010 For Beginners | Whip, Pause Technique (cut to the chase)

This video is for all the students that ask how I manipulate the 6010 cellulose rod. With not much explaining, I wanted you guys to see some vivid arc shots to understand my travel speed, rod angle, and manipulation. Thanks for dropping by. Peace

[stormbytes]

So glad I found this channel. A welding channel that ACTUALLY SHOWS WELDING! You'd think this was a no-brainer. Most channels are so focused on instructional they forget to SHOW YOU the actual welding. Very nicely done here. That 6010 must be a real nightmare to film!

[TulanePass]

This is what the students needed! Thank you. Bettered my game with this one. Also be careful on how close you put the phone, the arc noise and heat will burn your camera mic

[gilbertbrewer]

Darn good job. I’ve welded over 40 years. 6010’s have yellow jacket’s built in them. Lol.

[TulanePass]

Question: are you floating the rod or laying it on there where the flux is touching?

[raymondtrann]

Before you start the next rod are you supposed to clean off the slag from the previous rod? My teacher says I should, but I see a bunch of YT vids where they don't lol

[WestCoastFront]

I'm a noob welder, just got my D1.1 over a year ago. Why did you use 6010 instead of 7018?

[OsunaFabrication]

When you whip it
Do you jump the puddle or drag on it?

[angelcd]

Nah man, I’ve burned through the mesh vents of my Keens from 6010😂 always burning my foot😂😂