Mower Has A Blown Head Gasket?! Again?!

Replacing the head gasket on this 2010 John Deere LA115 riding lawn mower, again. Thankfully it's not a big deal, really. The blown head gasket made the mower hard to start and was showing blue colored smoke from the exhaust. Oil was even dripping from the fuel pump due to the extra pressure from some of the exhaust entering the crankcase through the oil passages where the leak occurred. If the head gasket was not replaced the engine would eventually burn up its oil supply and could seize up as a result. So it's important to replace the head gasket when symptoms arise. This is a Briggs & Stratton overhead valve (OHV) motor, very common on lawn mowers and lawn tractors of all sizes. In this video you will see how I diy replace the head gasket on this motor, actually for the second time.

DISCLAIMER: MARK YOUNG MAKES NO WARRANTY/GUARANTEE, EXPRESSED OR IMPLIED, AS TO THE RESULTS OBTAINED FROM THE USE OF THE INFORMATION CONTAINED IN THIS VIDEO OR ON THIS PAGE/PLATFORM, DIRECTLY OR THROUGH THIRD PARTY SHARING. UNDER NO CIRCUMSTANCES WILL MARK YOUNG BE RESPONSIBLE OR LIABLE IN ANY WAY FOR ANY CONTENT, INCLUDING BUT NOT LIMITED TO, ANY ERRORS OR OMISSIONS IN THE CONTENT, EXPRESSLY OR IMPLIED, OR FOR ANY LOSS OR DAMAGE OF ANY KIND INCURRED AS A RESULT OF ANY CONTENT COMMUNICATED OR IMPLIED IN THIS VIDEO AND/OR ON THIS PAGE/PLATFORM, WHETHER BY MARK YOUNG OR ANY THIRD PARTY. IN NO EVENT SHALL MARK YOUNG BE HELD LIABLE FOR ANY CERTAIN, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OR USE OF ANY INFORMATION COMMUNICATED ASSOCIATED WITH THIS VIDEO AND/OR PAGE/PLATFORM. THE INFORMATION PROVIDED SHOULD NOT REPLACE PROFESSIONAL ADVICE. THIS AGREEMENT ALSO EXTENDS TO ANYONE AND/OR ANYTHING, THIRD PARTY, WHICH MAY BE ASSOCIATED WITH THIS VIDEO, PAGE/PLATFORM, AND/OR MARK YOUNG. MARK YOUNG MAY, AT ANY TIME, REVISE THE INFORMATION ON THIS VIDEO AND/OR PAGE/PLATFORM WITHOUT NOTICE, AND MAKES NO COMMITMENT TO UPDATE THIS INFORMATION. NECESSARY SAFETY EQUIPMENT/ENVIRONMENT, DISPLAYED OR NOT, DISCUSSED OR NOT, IS UP TO THE USER TO DETERMINE WHAT IS NEEDED FOR THEIR OWN SAFETY, THE SAFETY OF OTHERS, AND PROPERTY.

[mikejohnson]

My 2012 D100 lasted me over 10 years without problems until now; a blown head gasket. The video helps a lot.

[HB-yqgy]

Thank you one-stop complete video start to finish!

[AlJacksonSongwriter]

You're the man ! .. and you performed that mower surgery with "Covid Belly". Unbelievable.

[mattb]

My 2009 LA115 with 305 hours had its fuel pump impulse vent clog with and leak oil, and then refused to keep running. Once warmed up, it would start and run for about 5-10 seconds, but then it would die because it wasn't getting constant fuel..because of the impulse clog. Cleaned the fuel pump and was able to start and run it, and finish a simple backyard dethatch/scarify..but it needs a head gasket.
First symptom was the smoke coming out of the oil-fill..before I even did the oil change. Never had that issue before.

[BBBILLY]

My John Deere D110 blew the head gasket at 65 hours. In hind site its been smoking for at least 2 years on and off. Sometimes VERY badly. Engine is covered in thick coating of oil and dirt. Thanks for this great video. Should help repair my beloved JD. As to JD and B&S.... shame on you both.

[clairkrause]

Yep, same problem on my Toro/Wheelhorse tractor with B&S single engine. After it blew the 2nd gasket I gave the tractor away and bought a JD tractor with a Kawasaki twin engine. I hope I don't have to deal with blown head gaskets again. It smoked like a steam engine,

[titonevarez]

very informative im very confident i can do this after seeing the video thank you

[KyleAdams]

I'm on head gasket # 3 in my LA110, just rolled 200hrs.

[robert_b]

Going to give this a shot .. save me hundreds in inflated repair cost.. problem is I don’t have all the tools like ft pound wrench

[tunnelwind]

on changing out the head gasket when all is clean and ready to put back together. can you use permatex copper spray a gasket on the part were you get the blow by. would that hold any better. or just replace the gasket?

[angusfoley]

Nice video, informative and easy to follow. Thanks

[therealwillie]

I got over 4 years on a troy bilt from 2018 before I got tired of decompression gear not working and I swapped it out for another lemon engine...

[markjohnson]

You forgot to do valve lash .. .004 intake .006 exh..
Prolly Heads warped if you torque them correctly last time. Take valves springs keepers off and take the head to a machine shop . Valve job and a replane..

[zaga]

Thanks for sharing, I lmao the part where she chasing you for the mower

[mR_Reddexe]

Clean the top of your battery! Believe it or not, but dirt/grim on the top of your battery will drain it.

[candlewoodmowing]

I have 2011 JD D110 with 19.5 HP Briggs and Stratton single cylinder engine, and had flawless engine performance until 242 hours. A valve rocker arm came loose; John Deere mobile maintenance repaired for $200. Now at 286 hours I had blown head gasket and valve seat that needed repair/replacement. Total cost $490. I am somewhat disappointed. It appears that valve issues are common with these single cylinder B and S Engines, and that twin cylinder B and S engines are more reliable.

[ImSrryBeingWhite]

How long did the head gasket before this last?

[MrEddieWoods]

I got 2000 hours on my factory head gaskets

[piotrpodlesny]

Everything sounds good except what is #of that gasket kit.

[schenard]

Dumb question. Do you have to drain the oil prior to doing this?