How to Connect Delco 10SI 3 wire Alternator

preview_player
Показать описание
We explain how to wire a 3 wire Delco 10si alternator and how to check for correct belt and pulley width and check to see if alternator is charging plus troubleshooting

Рекомендации по теме
Комментарии
Автор

Finally someone who can explain this simply and clearly. THANK YOU!!!!

settjessettje
Автор

Well done Sir! I can't tell you how many hours of my life that have been wasted watching videos produced by people who should be looking for a better way to spend their free time. I subscribed and look forward to your excellent produced instructional videos.

ryliepoopalotagus
Автор

You explain clearly and thoroughly, you do a great job teaching.

dennisg
Автор

Best video I’ve found yet thank you sir.

yourboydrewmoney
Автор

Thanks for coming back with a great video.

mauriciomarino
Автор

Thanks for blasting out my speakers (and ears) at the end of the video.

virgwamsley
Автор

Love the illustration it helped me out

josephkritzer
Автор

If I have a 3 or 4 post ign switch I dont need a diode or idiot light right?

garyalford
Автор

I connected the 10 gauge battery wire and the red since wire to the alternator post and tested the excite wire it has power. Excite wire not connected to any thing this seem odd to me the alternator will have power 24/7 . Looking at the alt blade connectors they appear joined together. Suggestion?
Great vid

chrisclarke
Автор

I have an 84 toyota 4 runner, has a 3wire plug, and 2 additional wires, im assuming both are grounds?? Wasnt hooked up when given to me

preacher
Автор

would the battery read the same 14.4 v if the alternator is working?

gn
Автор

How can I know if my alternator brush is bad

rexpetergodwin
Автор

Where do you get the connector kits from

legozombiemocmaker
Автор

Jay, I'm Hooking up the plyg into 10si the white wire with the diode, the diode was getting warm I had it hooked to a wire that's 12 v all the time, that's not right . I quickly unhooked that wire . Where does that hot wire go to the alternator ? It's 12 v even with the key off ???

Larry-gysi
Автор

So if it's putting out 16 volts and the connections are clean, it could be the regulator?

altpotus
Автор

How does the amp gauge or volt meter hook up ? thank you

fredzeller
Автор

can you tell me sir what is pin on me 12si alternator? be me I have positive linear voltage regulator inside the dashboard I use only pin 1 with baterry bulb the pin 2 is bend inside the alternator me car dont use that pin.
I have unusual problem when I use hv capacitors on me ignition system the alternator back charges up to 3000-4000rpm the alternator light come up always below that engine speed so how do I counter that problem???

MechanicForGMCCars
Автор

where did you get the wire with the diode inside

kenlelon
Автор

Will my kill switch shut off my car if i didn't have a dail in the white wire

duanenevelsii
Автор

What’s the benefit of an alternator if an older style generator actually will charge a dead battery and ALT won’t?

TruckThisGarage