Making a support brace and mohawk LEDs strobe

The plastic face mask has been trimmed to fit and now I'm going to mount the white LED strip that will run down the middle of the mohawk in between all of the fiber optic columns. The reason I had to add this strip is because the DMX LED controller that I got didn't support a strobing feature. Therefore, I had to purchase a strobing module that would give me intermittent strobing when power is applied (good enough for my application).

I also bend a piece of metal to act as a support for the Molex connector to make sure it keeps stress off of the cable tether. Once all of that was mounted, it was time to install the metal side piece I made earlier along with all of the chrome spike nut trim.

Hosted by Rich Tornetta

[TheAsphirosis]

You're really building the anticipation here! Can't wait to see the finished product.