my brakes will not bleed. no fluid flow in brake line. reservoir is full (thanks for all the help)

Too all of you who commented, thanks for helping. I greatly appreciate it.

[patsquale]

Open the bleeder and have someone push the pedal all the way to the floor and hold it until you can close the bleeder . Repeat this a few times until you have fluid . Works every time .

[chrismallia]

Open the cap let the fluid run out then you can bleed it

[MarcusWeinreich]

Maybe you have a kinked brake line. First take a screwdriver and separate the brake pads from the brake disks, make sure you have a couple of millimeters between disk and pad . Push the brake pedal as far as it will go and check the gap between disk and pad and if the gap has closed then fluid is reaching the caliper. If not there is a blockage between master cylinder and brake caliper, check the pipe!

[strati]

I personally had the line going to caliber rubber part swell shut try replacing it.

[kolin]

Probably has an autobleed function going to need a scanner if it does

[billyross]

Take the cap off or you wont get anything. If Worse comes to worse suck on the hose to mimic a pneumatic bleeder.

[jackiebrown]

bleed the master brake cylinder by having the brake fluid come out of both ports and back into the master brake cylinder then reconnect the brake line's

[notyetdeadyet]

boil the dumplings first then try hosing down the horse....

[maddexxx]

Unscrew the bleeder all the way and unclog it