Street/Race Powerglide Transmission: Final Assembly

[talbotracing]

Just came across your channel now. I'm going to steal your method to mount the ultrabell. Those o-rings are a pain. Thanks for including part nbrs and source.

[comp]

One thing I picked up fro Reid was to run bushing/busing or roller/roller and not mix from a concern of the oil following least resistance and passing through the roller side and leaving the bushing dry. Not sure if there is any merit to that but worth a comment. Keep up the great content!

[BigFunLife]

Can’t wait to see it in action..Great build Mr…Can’t wait for your next video always look forward to them..

[sethster]

Sheww looked up that gear set, man they’re proud of them.

[MHolt]

Love all the info on the power glide transmissions.

[jamieknight]

Great vid Shawn, thx for helping the fellow man

[Scofflaw_k]

This has been fantastic! Thank you Sir!

[jamieknight]

Hi Shawn, im building a Powerglide atm for a 400hp street car and your videos are invaluabe, thx. One thing, am i able to convert the standard valve body to full manual and do away with the governer? perhaps you could do small vid on what to do ?

[WayneBillings-htpl]

Did you install servo tube? It was missing when you installed the pan.

[JOMaMa..]

thank you for sharing your knowledge 👍

[MHolt]

Do you prefer to use Vaseline rather than the assembly goo?

[danielharms]

Is good idea to keep ears on bellhousing, can run a tap through them then use as mounting point for blanket.

[funfun]

You need to get it in the car and the car running, asap, before you sell this "Your" transmission! LOL

Will be cool to see you getting these builds running, tuning, and driving, too.

[pauldocherty]

Any cheap way to convert a fixed yoke glide to slip shaft setup?

[daltonnapier]

I realize this video is about 4 months old but a full cost video wouldve been cool

[carltotillo]

Isn't there a tube that feeds the servo for the band?

[jamieknight]

Shawn, when using the deep pan with the filter extension perhaps it's not necessary to fill to the 3/4 inch above pan rail level?