How to Replace Personal Setting Switch 02-06 GMC Envoy

Buy Now!

1A Auto shows you how to repair, install, fix, change or replace a damaged, worn out, faulty or shorted steering wheel mounted personal settings switch. This video is applicable to the 02, 03, 04, 05, 06, 07, 08, 09 GMC Envoy or Chevy Trailblazer.

🔧 List of tools used:

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[AAuto]

√ *Watch the Video*
√ *Do it Yourself*
√ *Save Money*

[jerryperry]

Thank you for this video. I was pretty sure they just pulled out but this video gives me the confidence to move forward in replacing all the controls in my 2005 Avalanche.

[ValNolanIII]

Good product. The wiring harness on the lower end were difficult. I used craft wire to hold the harness while I snapped the controls in place. The uppers are easy. '05 Silverado Z71.

[Aford]

I just replaced 2 out of the 4 switches on my 07 Chevy 2500HD Classic within the past week.  I found it slightly easier and less damaging to the harness if you remove the airbag from the center of the steering wheel using two small flat head screwdrivers prior to replacing the switches. From here, I take a small 90-degree/right-angle screwdriver, place it behind the steering wheel rubber to hold the connector in place while carefully sliding the new switch into place until it clicks (locks) in the harness.  I wish GM would have provided at least another inch to the harness - that would have made a world of difference.

[tomauerbach]

04 Silverado. I used a hook and pick set to remove and install mine.
You can get the hook behind the connector and pull into the switch. Some suggest using fishing line too.

[jimdent]

Will these switches fit my 2005 GMC Sierra? All my light bulbs have burned out.

[Nitronerd]

I have a 2003 Silverado 2500HD. What do you guys do when GM pulled the connector all the way to the back of the hole? There is almost zero play with the wire. There is no way to reach back there with pliers and hold the connector and slip in the switch. Will disconnecting the harness behind the air bag and horn help?

[MrEyad]

 can you show us how to remove Instrument Cluster . thank you a lot . 

[lyokofans]

Yikes those switches are expensive.  I have one with the lights out, but it still works so I will probably just keep it the way it is.

[backoffjoe]

that looks like surgery with sutures and everything.

[hbeachinit]

Seek volume replacement, harness was short on 2005 yukon. Tried other ways to connect this. Video grabbing with needle nose pliers worked well.