How To Replace Front Wheel Bearing & Hub 2005-10 Volkswagen Jetta

Buy Now!

Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision. This video shows you how to install a new wheel hub and bearing on your 2005-10 Volkswagen Jetta.

This repair was done on a 2009 Volkswagen Jetta SE 2.5L Sedan 4-Door FWD and the process should be similar on the following vehicles:
2005 Volkswagen Jetta
2006 Volkswagen Jetta
2007 Volkswagen Jetta
2008 Volkswagen Jetta
2009 Volkswagen Jetta
2010 Volkswagen Jetta

Tools you will need:
• 18mm Socket
• 21mm Socket
• 24mm 12-point Socket
• T30 Socket
• T60 Torx Socket
• Anti-Seize Grease
• Hammer

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ *Watch the Video*
√ *Do it Yourself*
√ *Save Money*

[timclark]

Man you made a daunting task seem effortlessly. Your precise and give clear and honest instructions. Thanks

[tjshire]

Nicely done. Appreciate all the torque specs.

[PICASO]

Awsome step by step I had a very good time doing my jetta thanks to your video👍👍👍👍

[haydenarmstrong]

Did the hub come with the bearing in it?

[joshmatthews]

currently struggling with this job, the bearing separated from the hub and it’s stuck on there, am i just not hitting it hard enough or is there something i’m missing all the 4 bolts are out and the axle is out

[predictionsproductions]

Hey there, I just bought a hub assembly for my jetta, I was curious do you need to remove the dust cover and add tractor grease and pack them?