2008 F150 5 4L phaser issue P0340, P0345

Truck has new VCT Solenoids (ford Part) Both Banks. It also has 1 new phaser (ford part) on bank 2 only. When the truck gets to operation tempter both phaser appear to get stuck in the position they were commanded to.

[PaulHenreid]

Same issue on 07 Expedition, is the best fix the camshaft phaser lockout?

[josejulianvega]

I have the same problem and I already changed the selenoids, what could it be, Ford 5.4 2005

[Maryahp]

Hello I have a 07 f-150 fx2 sport an I tried replacing the solenoid on driver side cause it was leaking oil badly. So after dropping tool down in engine an fishing it out weeks later. I had to take valve cover off to replace it an when putting everything back an the new seals would not fit at all an looks identical to the one I pulled out an is burning oil when I drive down road cause the seals are not on correctly.

[florenbaron]

My code is P0346. Is this the same issue?

[SuperArnold]

Mine does exact same thing, what was the fix?

[shoshonewarrior]

I have 2004 f150 getting code p0345 that’s the only code being thrown, I been inside the engine changed the tensioner rods new chains zipped the engine back up primed it and it throwing that code p0345

[patrickdspain]

Why not just leave them unplugged? What’s the side effect?

[robert]

Hello, I have a 2007 F150 with the same issue, how would this be fixed? I get the same codes P0340 and P0344. I have been driving the truck with the VCT sensor disconnected.

[GOOSECERVANTES]

I have the same isue 2004 f150 same noice same code
Along with the p0011 code
One guy told me new engine the other told me change the vct and it should fix the issue.
If the engine is below normal oil pressure then i need to swap the engine correct.

[muzafaralvi]

I have same issue new timing chain phase and all spark plud and coils still P0340 and P0345 where is houston tech located?

[preston]

I’m having the same issue, has anyone tried replacing the oil pump?

[ronr]

What is your contact info? I have p0345 on my truck and would like it resolved. I am in Houston. Thank you. God bless.

[torturedsoul]

my 08 did the same thing. i had code p0340 and replaced the pass side cam position sensor. 98% of the issues went away. If I try and feather the throttle then i have low oil pressure. The accelerator likes getting stomped on. So oil pump replacement in my future. Should be the final piece to the puzzle.

[forestgump]

You know that you could have just replaced the oil pump

[julioalbertoduranestrada]

Siempre qué fue
Soy de San Luis Potosí Mexico
Tengo ese mismo problema con mi camioneta
Ayuda

[AngelTorres-qufp]

I see the same cam pattern on my truck, theyre off