HOW TO USE J-B WELD EXHAUST REPAIR

J-B Weld Exhaust Repair pastes and adhesives are designed
to seal and structurally repair almost any part of your vehicle’s
exhaust system. These products are specially-formulated
to withstand extremely high temperatures.

[MrMOGHammer]

Just did mine with that exact same stuff, let the car run idle for 15 to 20 minutes it cooked and cured very well, roughly about 95 % of the noise is now gone. Had to wrap over the flange and carefully pinched it over that flange the hole was on the catalytic converter front just right at the flange and it worked

[jessiemckinney]

I’ve learned not to listen to those instructions I let it run for 15 to 20 minutes and exhaust gases were seeping through so I took it off re wrapped it with it again and let it sit overnight and it worked perfectly

[Cmoney]

How long does it take for the smoke to go away from the heat?

[DanielDavis]

U not show the tiger patch kit .it says to remove aluminium after finnsh. How is that possible

[jammiesypula]

I just used this and it started burning thr area I put the metal tape on. what do I do?