2005 - 2010 Jeep Grand Cherokee Amp and Sub Install

Parts used linked in the description below!

Watch a full tutorial as a 2008 Jeep Grand Cherokee will have a Pioneer amplifier and pair of subwoofers installed. This amplifier will be paired to an aftermarket radio that was installed previously. These subwoofers will be adding an additional 400 watts power over the factory sound system.

This video applies to Jeep Grand Cherokee models for years 2005, 2006, 2007, 2008, 2009, and 2010. This video also includes complete amplifier wiring, installation, and testing.

Click here to see the radio install video on this Grand Cherokee:

If you have any questions, leave a comment below! Be sure to like and subscribe!

Parts used in this install (Amazon Associate Paid Links):
*(Paid Link) Pioneer Amplifier GM-5500T 2 Channel Amplifier (Discontinued)
*Pioneer 12" Subwoofer (pair) TS-307D4 (Discontinued)

Radio Install Parts Used (See other video) (Amazon Associate Paid Links):
*Crux SWRCR-59 Wiring Harness and Steering Wheel Control Adapter:
--If you don't have the steering wheel controls use the Crux SOOCR-26:
*If you need the XM Radio Antenna Adapter, use the iDatalink SAT1:

*Disclosure: As an Amazon Associate I earn from qualifying purchases*

[ProvoBeastAudio]

Parts used linked in the description of the video!

[richp]

any good installer would also warn you NOT to drill into anything WITHOUT CHECKING first. I mean you dont want to drill into a gas tank or anything. just saying.

[crackercasey]

Need to turn that gain up or get a stronger amp those subs are not even moving

[kylesaunders]

Should have bridged that amp an wired those subs down to 2ohm that amp has more than enough power to get those subs moving

[derekklepper]

Thank you for this video man, very helpful. I have an 07 grand cherokee and was going to just drill a hoke through the firewall on the passangers side to run the wire but after seeing where you ran it through on the drivers side its much easier. And also help for the ground in back too. Thanks again.

[e_trippin]

Can I hook it up to the factory radio?

[honriG]

this is a good video, I used the same path for my power wire as you did, but as for the ground wire I would recommend you get bolted to the actual frame rather than a thing piece of sheet metal, a rear seat bolt is a good spot also as long as you clean the surface with a wire brush.

[tunacan]

I have 2008 grand cherokee boston audio system with sirius double din. How can I install amp and subwoofer? Do you have any diagram for cables

[todizzle]

I love how he says 8 gauge and it's 100% 4 gauge even sayscthat on the spool 😂

[nhlnms]

Slip on thru, slip on thru, slip on thru, slip on thru, slip on thru, slip on thru, slip on thru,

[mattgehrke]

My 05 jeep cherokee has the Boston acoustics sound system without steering wheel controls. Do I need a special interface in order for the factory amp to work with a aftermarket radio?

[shanegarry]

I have a after market radio kvt 14 Kenwood DVD works fine plays music no problem… but im installing a aftermarket amp I ran the power and ground and remote… turns on and off like it should but I have no sound coming from the amp .. amp is new / and new amp kit .. my truck does have a interface ? Could it be the remote wire ? This install is throwing me for a loop lol .. just looking for some info thx

[jasons]

You should have mentioned to always run the remote wire on the opposite side of the power wire to avoid noise or is that not done anymore.

[roseaesthetic]

Appreciate you ❤ talked to some guy at Duke's and he told me that because it was a jeep there was nothing I could do. I think he just hates jeeps lol

[ohmwrecker]

You make this look easy running some 8 gauge wire. I'm trying to run 2/0 wire, and it's a pain in the butt lol.