How To Layout And Cut Hip And Valley Roof Rafters

Help support Doublewide6 Repairs LLC by sponsoring his Patreon account

Doublewide6 Repairs LLC has a Master’s Degree in industrial technology with a specialization in Manufacturing, due to factors beyond the control of Doublewide6 Repairs LLC and anyone featured in his videos, I cannot guarantee against improper use or unauthorized modifications of this information. Doublewide6 Repairs LLC assumes no liability for property damage or injury incurred as a result of any of the information contained in this video or any of Doublewide6’ Repairs LLC's videos. Use this information at your own risk. Doublewide6 Repairs LLC recommends safe practices when working on equipment, power tools, chemicals, electronics, electrical systems, vehicles, and or with tools seen or implied in this video. Due to factors beyond the control of Doublewide6 Repairs LLC, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Doublewide6 Repairs LLC.

[Sgtzo]

Did you jack rafters line up over your studs 16oc?

[alteckk]

This was very informative. Thanks. Weird question what do you do in a case where the roof run is longer then any board available? Would you just join two boards together?

[viktorzvrn]

Thank you. How to calculate the corner rafter if the outline of the house has angles not 90 degrees?

[robertshields]

This is a guy you want to teach you how to cut a rafter

[donegalireland]

Would love to see that hip offered up.
Do you not allow for dropping or backing the hip to allow the common to run through.
Such a pity you over cut the heel and seat cut.

[roxydog]

Check out a little (old school) with Larry Haun he's got a few vides out... How to Build  Floors, Walls & Roofs.

[jamesstacey]

after all if it's getting sistered to a joist covered with sofit an hidden with drywall you will not see it and again the value is where it's sitting

[mrmuskey]

I use a hand saw or Jig saw to cut Birds mouth. Skill saw weakens the wood

[mikeso]

If common pitch is 7, hip/valley won't be 7, right?