FRP Wall Board Cutting Video

This video shows an easy DIY way to cut Fiberglass reinforced plastic (FRP) | Wall Panels. It's informative and easy to understand. It's an alternative to most of the videos I've seen here and it doesn't take a professional to cut the material. It doesn't have the necessity for any special tools either. I used a T-Square but any straightedge will work. I hope you find this video usefull.

[focklersd]

Perfect! Just purchased 4 sheets for our facilities kitchen. I was told you can cut with a sharp razor knife. I just came to watch the video and I am confident in cutting. Thank you for the quick video.

[claymeinke]

Been doing it this way for almost 20 years, no power tools need. If you need a finished edge you can score and snap it long and then clamp a straight edge
on your line and run a router alone that PS, make sure you score the underside not the show side it does score well and you could damage the sheet.

[johnlibonati]

Fantastic video. I only have 3 sheets to cut. I've used a circular saw before, but I like how straight and clean this comes out. I will try this tomorrow. Thanks!

[MrJimgillnm]

Lonnie my Man !

Well Done !

Thank You for producing this educational video !

[canosl]

Thank you my friend. Very simple way to cut it.

[njseashorechas]

Cutting whiteboard in the Bahamas. Does it get any better than that??

[mikef]

You solved the question I had in my mind …….. thank you bro ……….

[DoctorGnu]

OK and what happens when you have two angles to cut like around a window ?

[lorivanatta]

Perfect video. We are tackling this today and wondering the best way to cut this panelling

[captlarry-]

This would sure have been my first approach... and as long as it gives a smooth enough edge to slide into the plastic trim pieces ( if you are using them) I think it makes great sense ! No dangerous Fiberglass Dust, no electricity required. And you get a dead Straight Edge. No I am going to try using some shears.. because I dont need that much accuracy, and it is easy to do along on the floor. but if that doesnt work out.. this is how I will cut mine.

[danjenlilyful]

Possible to toss it up and router out windows?

[fiberglasssheet]

Thanks! This video is very useful! we can offer this embossed panel too!

[davidsiebert]

Thank you!! Its been so long since i have had to cut FRP i went from the front. NOt good

[petesmusic]

Thanks for the video, I was thinking that using a blade would be a good option, and u Confirm that thank you very much

[spagsketti]

Okay the echo of you being in a very large empty room is painful even with the volume turned down. It is literally ear piercing.