Root welder 1g 6013! Cap 7018

Today I will show you how to welding?

#howtowelding #stickwelding #welders

[dustyluce]

6013 is a light penetrating rod used for sheet metal and thin metal welding.

6010 is a deep penetrating rod. You're supposed use it for open root welds for 100% penetration and then the hot pass.

[Mistabushi]

The point of doing cap with 7018 is when you use 6010 cellulose rod and low hydrogen cap(7018) prevents cracking in a nutshell. Stay away from 6013 rods, they're shit in most cases and good for welding gates, some minor repairs etc. Slag inclusion is a bastard too.

[MrDrRemi]

So I’m today years old and I just learned you can throw a root in with a 6013. Friggin welding man

[jackross]

I was always taught to put a root face on the joint so flattening the point of the V…

[brunoblanc]

C'est la racine qui est importante dans la démonstration. Dommage que l'on ne puisse la voir !
Il serait bien de faire une démonstration avec l'électrode enrobée basique. Racine en polarité inversée.
Merci

[edsantos]

We limit 6013 to plates only.. 3/32 at 3 mm gap good choice.. 👍👍

[indicol]

When I first learned how to weld in school. Chasing that key hole was a pain in my ass

[dustyluce]

You could probably just ran 7018 all the way out. Imo it's easier to run then 6013. Plus then it's all 70, 000 tensile strength deposited weld metal.

[eddymack]

why do you need that gap instead of butting the pieces together?Im not a welder I am just curious

[morenothingu]

How many slag inclusions was in there?

[julijannajger]

Ti imas variskra 250amperski inverter ter tudi ac/dc za tig dodatno. Carsko

[joshcormier]

Poor rod choice 6010-6011 fast freeze high penetration would have been the preferred choice over a low penetration 6013.. which is usually used on sheet metal 😂😂

[johnscarboroughregenerativ]

don't mean to be rude but why do people post videos of them welding when thay haven't Learned to weld yet? is it so we can help and give pointers or is it because thay don't know they can't weld yet? I mean I'm not saying its that bad but it's got a ways to go before it's show worthy.

[jasonrudy]

Side to side is better not back and forth. You will trap slag in the root pass.

[FajnyKtos]

Jak ta spoina wygląda na końcach? Ja bym się tym nie chwalił!.

[jorgealvarofernandezacosta]

La raíz se debe hacer con electrodos CELULOSICOS TIPO QUEDA MUCHO MEJOR QUE CON RUTILICOS - (TIPO 6013)_además el celulosico (6010), no tiene escoria.... COMO LOS RUTILICOS

[WeldYouLookAtThat]

Well it looked good for about 3 seconds till it showed the 6013. The fact they are using a 6013 makes me question this whole things legitimacy.
6010 Root with 7018 hot pass. Fill and cap with 7018.

[alejandrormbo]

6010 its beeter for the rooth pass i guess

[tomthompson]

prep is really nice, ,, the welding is crap.

[antonioortiz]

60 13 no sirve para soldar, ese calibre de placas, mejor 70 18, buena resistencia y gran penetración,