[Solved] ESP8266 NodeMCU/ESP32 esptool.py fatal error in Arduino IDE 2024 Updated

This can happen due to various reasons, typically related to hardware connections, software configurations, or timing issues. Probable solution are given below :

Driver Issues: Update or reinstall the USB drivers for your ESP board, especially if you're on Windows.

Port Selection: Choose the appropriate COM port your ESP board is connected to under "Tools" ,"Port." You might need to check your device manager or system settings to identify the correct port.

If the above 2 solutions are not working follow the process given below .

Flash Button: If your ESP board has a dedicated flash button, press and hold it while uploading
Reset Timing (ESP8266 Only): For ESP8266 boards, the timing of holding the reset button during upload is crucial. Try these approaches:
Hold the reset button before plugging in the USB cable, then release it a second or two after uploading starts.
Press the reset button repeatedly just before you click the upload button in the Arduino IDE.

USB Cable: Ensure you're using a good-quality data cable (not just a charging cable) that can transfer data reliably. Try a different cable if possible.

[vntbsar]

Cp2102 driver installed, libraries also installed still not working, I am getting same error even my MCU has mentioned cp2102 driver that I installed successfully

[sechi]

Gracias hermano. muchas gracias, me funcionó. Un fuerte y caluroso abrazo, bendiciones.

[vntbsar]

Even changed laptop but nothing worked