How to Replace Oil Pressure Switch 2003-2007 Honda Accord

Buy Now!

This video shows you how to install a new Oil Pressure Switch 2003-2007 Honda Accord.

This repair was done on a 2006 Honda Accord EX 2.4L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2003 Honda Accord
2004 Honda Accord
2005 Honda Accord
2006 Honda Accord
2007 Honda Accord

Tools you will need:
• 24mm Socket
• Safety Glasses
• Drain Pan

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[xMrBlack]

Will a bad oil pressure switch throw a code or just the oil light?

[teyob]

What is the size of the socket that you are using? Thanks for your time!

[JTient]

Thanks I did this with a mechanic and used Teflon tape for sealing be careful screwing it back in it can crack the block.

[rearviewofworld]

Hi TRQ team, Thanks for the video. Can you make a video of how to change the reverse light switch in Honda Accord 2003-2007 as I am having a lot of problem locating the switch? Thank you so much and keep up the good work.

[andresbaut]

what are the symptoms of a bad Oil Pressure Switch?

[josephperez]

if your replacing the Vtec Solenoid Spool Valve 15810-RAA-A03 isnt the oil pressure switch on it?

[SKkold]

My wiring harness is stuck what do I do

[Gabriel-cgsk]

is this the same thing as vtech oil pressure switch

[meechgold]

I’m doing a 2010 with this motor n the socket end of the sensor is literally cover can’t get nothing around it

[austinpasta]

I l gave it wiggle and hardness is stuck on it