What are VLANs and how to configure them (pt.1)

Показать описание

In this Part 1 of a series, Druvis will take you deep into the wonderland of MikroTik VLANs. Let the journey begin.

Рекомендации по теме

Комментарии

please show the WinBox interface for configuration, not just the CLI, in the next video if you're doing Bridge VLAN filtering . Thank you

knightsljx

Very well done. I've been networking for over 25 years and teaching CompTIA Network+ courses for almost 20 years, and this is an excellent explanation of vLANs.

bkspeck

Glad to see these guides. When I first got my RB5009 I struggled a lot with creating a trunk port to my Hap ax^2. It seemed quite a bit different from previous gear I worked on, however, it's not actually that different once you get your head wrapped around the way of adding bridged VLANs.

dbjungle

I wait for that video long time ! Good introduction in vlan, I wait for more !

SiBex_ovh

I'm sorry this video is still not clear enough, The Network Berg's video on this as part of MTCRE is much clearer and in-depth... explaining three approaches and giving examples on how to achieve both via command line interface and winbox GUI

NarcoticEvil

This was a good video. I will rewatch it again a few times.

sheridanjegels

At last. Hope you will en these series with detailed description of such complicated setup like router, switch, capsman + several AP and VLANS with local, guest and managemant networks on one bridge with VLAN filtering.

hatsid

exciting series! am hoping this series will be comprehensive and cover some use cases like management networks, wireless and perhaps even containers

xqrkang

Great stuff! Excited to see what the vlan videos with the CRS3X is like. I’ve had issues with BPDUs flooding along with maybe CDP that forward these packets and cause connected Cisco switches to shut down ports.

Joshv

This is something I’ve avoided as the last time I tried bridge vlan filtering I broke everything, thank goodness for safe mode. I can’t wait for the next episode in this series.

MarcEasen

Great guides. Thank you MikroTik Nerd.

lb-eT

Normally when I see his video. I do pause to watch it . Very informative

mikkio

When you do cover the bridge method, please take some time to explain the different parts of the config, and go over what @sindy discusses in his forum post "RouterOS bridge mysteries explained". Important concepts: Base interface with untagged traffic. Vlan interface and what it does. What the bridge represents. And what the /interface bridge, /interface bridge vlan, and /interface bridge port commands do.

What would be helpful would be to configure a router (e.g. a 5009) with an ether port configured as trunk port to a CRS326 switch, and then show how the Router can route traffic between two access ports in different vlans. Then once that is explained, reconfigure the 5009 with the vlan-filtering bridge, and configure a trunk on the bridge to the CRS326 (i.e. convert the trunk from a ether port based trunk to a trunk port on the 5009 bridge. Leave the CRS326 config the same. Show that the behavior is still similar. Then expand and also configure access ports on the 5009, and show that traffic from an access port on the 5009 to an access port on the CRS326 in the same vlan does not involve the CPU. And that the 5009 can act as a router with an integrated vlan-aware switch. (the L009 could be substituted for the 5009).

jonpinkley