How To Level Your Bed on the Ender 3 S1 Pro

In this video, I show you a step-by-step guide on how to level your bed both manually and automatically.

Consider supporting the channel

[williamjohnlittle]

OK Dan, I am happy following that process, both the aux and auto. One thing I noticed the aux run then the auto run sets the centre #1 position slacker. Now I received a usb with nothing on it, not an issue as they say you can download the latest information from the site. I cannot find a flow chart for the control pad, and i am not to happy downloading the software update as so many are bricking the control pad can you do a vid on the software download and install for the elderly. Cheers my friend. WJL.

[tkSARGON]

Can someone please help me? My printer is working fine for about 2 months since I bought it. And randomly when I do these same steps to level the printer. I can't move to the certain point no matter what I press on the screen. It just stays in the center and his way to far away from the bed. Not sure what to do I need help

[georgeanastasiadis]

cam you make a tutorial how to upgrade the software, to the latest.. cause i try and cant figure it out
\

[sickswan]

Any advice as mine isn't writing the mesh the grid numbers just stay white at 0.01

[Imaginebricks-bptj]

how would I edit the leveling with the screen and will it stay how I edit it

[denisdb]

Hello, When I start the leveling as in your video at 2:31 I do not have that screen with all them numbers but a view in % of how mutch is done in de proces. How comes and what can I change to have the same view on my screen?

[HermitMerc]

I’m having a problem where no matter how many times I do it there is a section near the middle that won’t ever get close enough to the bed, all corners are pretty much perfect and that spot is bad

[kutsanan]

i have a ender 3 s1. after latest fw there no option for manuel leveling

[georgetzortzinakis]

What does edit do on the values of the leveling??

[brunocosta]

Hello Dan, I'm going to start in 3D. Which of these two printers would you recommend, the ender3 S1Pro or the Sovol SV06plus? Thank you and I really enjoy watching and learning from your videos. Best wishes and thank you👍

[peighday]

After the latest firmware update I have an issue with the ABL. I perform the steps exactly as you do however after setting the bed mesh and running the ABL the Z offset will change dramatically. In my instance I set the Z offset to -4.90 when doing the manual bed mesh. After running the ABL the printer pushes my extruder into my print bed and I need to adjust the Z offset to a higher position and in my case -3.85. I have reset the printer multiples times, reflashed the firmware, and still have the same result. Any ideas on how to fix it?

[MordCosby]

How do I download the latest firmware to my printer?

[ScottAlexander]

What firmware are you using in this video?