2008-2012 Honda Accord Front Wheel Bearing Replacement / Without A Hydraulic Press

Accord 2008-2012 front wheel bearing replacement are all the same procedure.
Here are some of the tools that jimthecarguy uses

Due to factors beyond the control of jimthecarguy, it cannot guarantee against unauthorized modifications of this information,. jimthecarguy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. jimthecarguy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of jimthecarguy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not jimthecarguy.

[navanava]

I feel like I'm watching my dad work, thanks a lot pops!! You're a great teacher.

[marktumlin]

I love your videos very informative. I have to do this for a 2016 Honda CRV. Should be a similar process. The only thing I do different when pressing in new bearings is, I put them in the freezer overnight it makes them slide in so much easier. And old-timer showed me that years ago. Again thanks for the video

[mktwatcher]

Excellent Auto Repair Man, I Love his Calm Demeanor too.

[cdhughhgjbno]

Thks for clearly showing us the hub assembly process by holding the back before pressing in the hub... a lot of YouTubers don't bother trying ... great video

[keithameerali]

He said no talking but he explained everything pretty good. I have a feeling he can't keep a secret. Great video.

[eddien]

Quality job my friend. Thanks for the very detailed and descriptive tutorial!

[flyabove]

Jim, your instructional video is truly excellent. Most informative and detailed. I can tell you're a great mechanic! You have great attention to detail. This job wasn't an easy one, but you did it superbly.

[barrykery]

I have a bad wheel bearing on my 2014 Accord. I see I won't be doing this job. I lack the tools, the puller to be exact.
Very informative and interesting video.

Barry

[eldoradony]

I bought that kit after I saw it used on a SMA video. Eric O uses a thrust bearing on the forcing screw. I followed his advice and do the same. It seems to reduce the wear on the screw shoulder.

[arthurfricchione]

Jim, another excellent video thanks you for sharing Artie ❤️

[garyvanremortel]

Always install snap rings with their gap facing down so that moisture can exit by gravity.

[anthonygiordano]

Great video sit thank you . Going to be doing my front wheel bearing soon and this will help a lot. Take care

[billyba]

Currently attempting to tackle this project.... Thanks again for your video!!!

[tonggi]

Excellent video. Very informative. Thank you!

[brockysoup]

Thanks for taking the time, Jim. Great video!

[oscarmejia]

Hello thank you so much for everything you have done great teaching.

[glh]

Great video!... and dialogue explaining as you go through each step! Unless I missed it, when the race was removed from the hub I didn't see where it was replaced. Does that need to be replaced?

[nilolee]

I subscribed to your channel cuz I know you’re good and doing it professionally. Would this be the same procedure as in 2014 crv and do I need to do wheel alignment after if I remove the knuckle from the vehicle? Thanks

[patrickl]

Excellent video. It made the job easy!

[damaxpowerway]

Should I replace the front hub assembly and bearings to replace a broken off dust shield and go through taking apart the entire front end of the car like this or am I better off jumping off the golden gate bridge and calling it a day?