How to Replace Front Steering Rack and Pinion Bellow 2008-2012 Honda Accord

Buy Now!

This video shows you how to install a new steering rack bellows boot on your 2008-2012 Honda Accord. The steering rack bellow is a plastic or rubber cover used to protect the joint between the steering rack and the tie rods from dirt, debris, water, and other contaminants that could corrode or damage the tie rod joint.

This repair was done on a 2010 Honda Accord LX-S 2.4L Coupe 2-Door FWD Manual and the process should be similar on the following vehicles:
2008 Honda Accord
2009 Honda Accord
2010 Honda Accord
2011 Honda Accord
2012 Honda Accord

Tools you will need:
• 24mm Wrench
• 19mm Socket
• Pliers
• Side Cutters
• Marker / Writing Utensil
• Hammer

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[mickbrown]

great video and clarity!!! thats why i would rather pay the professionals! too many things that can go wrong.

[profilename]

You’re saying I can get all this done in 9 minutes! :P

[junny]

Great video, thanks! Do I need to put grease on the inner tie rod? The part where the bellow goes.

[paulyassy]

disconnected the battery to change a rack and pinion boot?

[thadonofdetroit]

Are there ANY videos on the rack and pinion replacement for a 2012 Jeep Grand Cherokee overland 5.7L?

[johndoh]

Do you have to grease before you put bello back on

[markk]

So when exactly were you going to show us how to change the rack and pinion?

[jaydeex]

This is Inner and outer tie rods replacement no ?

[bee]

This is not rack and pinion how to am i right or wrong

[cesarzaragoza]

You never replaced the rack and pinion ! I call that false advertisement or click bait ! Waste of time with the title!

[nickschnur]

But how do I replace the REAR steering rack and pinion bellow???😂😂

[ndxmotorsports]

That not how u remove a rack an pinion thats a out tie rod job wrong video this needs to be fixed asap