Nautilis WiFi Temperature Controller

Using the Nautilis WiFi Temperature Controller brings you a number of benefits, both due to a timely response as well as setting the temperature when you are not near a fermenter, aquarium, terrarium or where you need to control the temperature. WiFi is required to operate the device as parameter setting and device management are done through an application that can be used on cell phones or tablets. All the settings you specify by the application are saved in the brain of the device and remain stored there, which way the device works and does its job even if there is no internet. The unit has 2 temperature sensors. One is waterproof with 3 meters of cable and the other is built into the box to measure the room temperature.

The prototype of the device has been developed and tested for more than a year and has produced a series of beer fermentations without any problems. The firmware for the device is constantly being upgraded and improved as well as the development of PCB board design.

The device is designed so that in the event of a failure, it is possible to replace the parts without any major problems and eliminate the failure.

The parts that are built into the controller were purchased from proven manufacturers and reputable brands, and care was taken to ensure that every bit of the device was one, as reliability and durability were the priority.
Some of specification:

– Setting the desired fermentation temperature, water etc. through the mobile application
– Temperature hysteresis at which the cooling or heating relay is switched on
-Delay – Delay time for turning on the cooling or heating
-calibration of temperature sensor
– graph of temperature in the given time
– alarm from high temperature (sound, mail, mobile)
– low temperature alarm (sound, mail, mobile)
– display on your cellphone the status of heating or cooling on
– display of actual, set temperature, heating or cooling status on a low-energy dual-color oled display.
– protection against failure or error of the temperature probe (reported by mail, mobile phone and audible alarm)
– Wifi termination notification
– The temperature probe can be extended indefinitely without affecting the measurement quality
– it is possible to connect multiple controllers in one box of the device
– application allows to connect multiple devices even for different purposes into one unit, thus simplifying control and setting of parameters
– no data loss in case of power failure energy or the internet.
-designed so that all parts in case of failure can be replaced,
– possible OTA (Over the Air) firmware upgrade (via web interface)
-design of the device according to personal needs, possible with one relay without sound alarms etc.
-blue LED indicates that the fermenter is cooling – red is heating.

What updates are coming soon?

Support for digital hydrometers. The prototype controller is currently being tested, which will be the centerpiece of the home brewery, and the latest prototype has built-in support for receiving data from several digital hydrometers at the same time. This will make the hydrometer no longer need the internet to operate.