Predator 301cc engine 1 year update and cold start

Links to products I have in my tool bag.

Above are affiliate links which means we receive a percentage of the revenue made from purchasing products via those links.

Thanks for watching. Its leaf blowing season so I have to make sure my blower is working like its supposed. New tires and wheel were needed but I hope it starts easily.

The last video where I install the engine into a Little Wonder Leaf blower.

[lukeWiz]

Love the wide open property. Good thing you got that blower!

[ronaldbechler]

I would go with the hard rubber like you did. Seems like everything I have small pneumatic on they are always flat. Especially after they have a few years on them. Thanks for the videos. Ron B Michigan

[robertmailhos]

Congrats on the one year anniversary of the engine swap I would go to the higher price, d tires makes one thing to have to check when you get it out of storage see you later young man

[RussellBooth]

I would go for the.solid rubber tyres due to the dry rotting.issue with the pneumatic.tyres !

[jerrysoutherland]

I have a 33" troybilt mower, with pneumatic tires that are dry rotted but ATF In the tires still holding air 20 years old walk behind mower.

[PilotViewProductions]

Nice video. Just wondered if that unit is hard to pull start since it sounds like it's spinning up some sort of impeller blades. I had a push-type vacuum (built more like a lawnmower than yours and yours is a blower of course) that was extremely hard to start because there was no way to disengage the impeller on start-up.

[lewiemcneely]

Not sure. Those blowers are sure handy.

[alanlake]

Just blowing the leaves to the side seems a waste of time to me as the wind will just blow them back again, would be better if they could be bagged up at the same time . Probably go with the solid tyres myself .

[noahdurfey]

I'd go with more expensive pneumatics for my own use seeing as it's not used often. If I I used the machine commercially I might consider solid ones.

[albertosanchez]

Hello! I'm having trouble with a gas powered air compressor. I 've replaced the unloaded pilot valve, but now the valve where you bleed air out is popping off before it builds air up to 135psi any ideas anyone? Please and thank you

[Patrick]

I guess on the tyre part everyone is different