Replace the Display Panel | HP Stream x360 11-p000 Convertible PC | HP

Learn how to remove and replace the display panel for the HP Stream x360 11-p000 Convertible PC.

Follow these steps to remove and replace the display panel for the HP Stream x360 11-p000 Convertible PC.
- Before you begin, Remove the display cover, webcam, and P-sensor board.
- The following procedure should only be performed in a clean room environment.
- For removal, take of the metallic tape that secures the wireless antenna transceivers to the display panel
- Make note of the placement of the tape that secures the display panel cable to the display panel assembly.
- Remove the tape that secures the display panel cable to the display panel assembly.
- Make note of the routing of the display panel cable for later replacement.
- Remove the display panel cable from the routing channel and adhesive on the display panel assembly.
- Peel back the retention tape and disconnect the display panel cable from its connector on the touchscreen control board and display panel.
- Remove the display panel cable and set aside.
- Remove the tape that secures the wireless antenna cables to the display panel assembly.
- Remove the wireless antenna cables from the routing channel on the display enclosure.
- Remove the 2 mm P1 Phillips broad and two 2.5 mm P1 Phillips -head screw that secures the left display panel hinge to the display panel assembly.
- Remove the 2 mm P1 Phillips broad and 2.5 mm P1 Phillips head screw that secures the right display panel hinge to the display panel assembly.
- Lift the display panel assembly to open the display panel hinges.
- Remove the display panel assembly alignment pins from the display panel hinges and place it on the top cover.
- Remove the three 1.5 mm P1 Phillips broad-head screws that secure the display panel to the touchscreen glass.
- Lift the display panel off of the alignment pins on the touchscreen glass and remove.
- For replacement, place the display panel onto the alignment pins on the touchscreen glass.
- Replace the three 1.5 mm P1 Phillips broad-head screws that secure the display panel to the touchscreen glass.
- Lift the display panel assembly and place it onto the display panel hinges with the alignment pins.
- Replace the 2 mm P1 Phillips broad and two 2.5 mm P1 Phillips -head screw that secures the left display panel hinge to the display panel assembly.
- Replace the 2 mm P1 Phillips broad and 2.5 mm P1 Phillips head screw that secures the right display panel hinge to the display panel assembly.
- Carefully close the display panel assembly so that it rests on the top cover.
- Route the wireless antenna cables through the routing channel on the display enclosure.
- Replace the tape that secures the wireless antenna cables to the display panel assembly.
- Connect the display panel cable into its connector on the display panel , touchscreen control board and replace the retention tape.
- Route the display panel cable through the routing channel and adhesive on the display panel assembly.
- Replace the tape that secures the display panel cable to the display panel assembly.
- Carefully adhere the metallic tape that secures the wireless antenna transceivers to the display panel.

Caution: Improperly installing or replacing parts could damage your HP device or void your warranty. Before replacing any parts, check your warranty.

Continue the Conversation:

#HPSupport #HPComputerService #HPstreamConvertiblePC #HP

About HP:
HP Inc. creates technology that makes life better for everyone everywhere — every person, every organization, and every community around the globe. Through our portfolio of printers, PCs, mobile devices, solutions, and services, we engineer experiences that amaze.

Connect with HP:

This video was produced by HP.

How to Replace the Display Panel | HP Stream x360 11-p000 Convertible PC | HP