Mini 3D RC Plane | Review and Flight

Показать описание

All the info and links here...

This is a small review of the MINI 3D Airplane Kit from Banggood, very nice and does what it should, needs a bit of time to build it and it's fun to fly it.

List of electronics:

Website

Become one of us:

Facebook
Instagram

#JoyplanesRC #HobbyRC

Рекомендации по теме

Комментарии

Thank you very much for your comprehensive video!!! I received my sakura today and I'm going to attempt to assemble it.

hitekredneck

I have this model partially build in the basement for about 8 years, its badsically the same as your one.
I might pick it up again.

knicklicht

Cool video joy. I love micro 3d aircraft!

m.s.aviation

Hello, I couldn't find the UHU brand POR type of foam glue to reinforce the parts of this airplane, therefore is it okay to use Hot Melt Glue in medium temperature to reinforce the parts of this airplane?

sujihettiarachchi

Damn that music at at 1:15 is 🔥
I was totally staying to freestyle in my head 😂

americanbrandon

its cool how it looks like an f3p slow flyer but it flies fast

vanditsharma

Hello, I received this kit version(without any electronic) of E010 Sakura airplane from AEORC factory so I weight the overall body parts of the package included all items but excluding the instruction manual, the weight was 38g(grammes).I searched every where to buy likes this UHU por type of glue but unfortunately, the oversees air transportation doesn't support to ship the glue items through the air. Hence I measured the weight of just only one stick of glue gun stick, it was 10g(grammes) so I asked from the factory that will it fine to use the Hot melt glue for reinforce the parts of this airplane so they said that if I used the hot melt glue the aircraft overall flying weight will be increased so as the result, it would be hard to fly, hence use a specified glue for foam. I am using very light weight electronic components like 2g servos, a 1106 brushless motor with prop saver and a 5030 propellers and a 8g of weight ESC, with a ELRS micro receiver and this Byme A flight controller, I just prefer to build this model to fly on 1s(3.7v) and so far the motor unit can trust 165g in weight when supply 2s power, therefore if I prefer to build this airplane in 1s(3.7v) power and with using the hot melt glue for reinforce the parts, will it fly fine without any issue?

sujihettiarachchi

I love when you upload a vid about a micro rc planes ;)

wjsbruwer

if i have flysky i6 remote control and his receiver this plane work???

kxdmotovlog

Hello Joy vas a subir el mismo video al otro canal no

josedavidbanegasalpiri

Your troubles with motor loks me like bad timing setup. You can reed manual which was suplied with ESC how to setup higher timing. Very simple procedure just listen beeps and moveng throtle up and down based on count of beeps. I bouth it as well and it works well. I am just little bit disapointed that servos are quite slow. Whole system works on low voltage 4.7v. definetly it will be improvizace to run it on 6v but it means diferent esc may be receiver as well. Or buy better servos. Both ways are dificuilt and expensive for me so i set it up to use just part of servo stroke(70%). I lost resolution and force but gain speed i hope it will be ok. Enjoy flying bye R.

radekjakl