SAKURA - 3D Mini - Smallest Airplane

[annashuller]

Nice plane i also want to start flying 3d

[NilukaShiromini]

Dear, can I use hot melt glue to stick the foam parts of this Sakura airplane and will it burn the foam if I use it?

[agungcahyono]

I have this new sakura magic board type, hard to control.

[sujihettiarachchi]

I received this kit version(without any electronic) of E010 Sakura airplane from AEORC factory so I weight the overall body parts of the package included all items but excluding the instruction manual, the weight was 38g(grammes).I searched every where to buy likes this UHU por type of glue but unfortunately, the oversees air transportation doesn't support to ship the glue items through the air. Hence I measured the weight of just only one stick of glue gun stick, it was 10g(grammes) so I asked from the factory that will it fine to use the Hot melt glue for reinforce the parts of this airplane so they said that if I used the hot melt glue the aircraft overall flying weight will be increased so as the result, it would be hard to fly, hence use a specified glue for foam. I am using very light weight electronic components like 2g servos, a 1106 brushless motor with prop saver and a 5030 propellers and a 8g of weight ESC, with a ELRS micro receiver and this Byme A flight controller, I just prefer to build this model to fly on 1s(3.7v) and so far the motor unit can trust 165g in weight when supply 2s power, therefore if I prefer to build this airplane in 1s(3.7v) power and with using the hot melt glue for reinforce the parts, will it fly fine without any issue?