SuperATV Complete Transmission Install | Polaris RZR XP 1000

In this video we show you how to install SuperATV's complete heavy duty transmission into a Polaris RZR XP 1000.

When your transmission stops, you stop. We know, we’ve blown more cases than we can count. That’s because this masterpiece of machinery makes your UTV do what you want it to with the perfect amount of power. And SuperATV has made it better, stronger, and more reliable with our Complete Heavy-Duty Transmission for the Polaris RZR XP 1000. It’s made to order, then thoroughly tested before it ships to ensure perfect quality and maximum performance. We lap our gears to give you a 100% perfect mesh so you can drop this transmission in and go with no break-in period. With upgraded internals and a better case, our transmission will power through the trails that made your OEM case explode.

FEATURES
Complete, assembled, drop-in transmission
Designed to address OEM weak points
Built to order and thoroughly tested
Lapped gears ensure perfect mesh
Upgraded snorkel gear set
Made with 9310 heavy-duty steel
2.5x stronger than stock
Lapped gears are mated perfectly for less wear and smoother operation
Eliminates a major weak spot in the transmission
Strengthens the entire drivetrain
Upgraded reverse chain
2x stronger than stock
Quieter than the competition
Upgraded transmission case
More support ribs and gussets than stock
Extra fins help keep your transmission cool
68% more metal reinforcing the snorkel tube and axle output areas
Includes all necessary seals
Includes necessary plugs and shifter shim
Multiple gear reductions available
Stock gear reduction
12.5% gear reduction
25% gear reduction
Does not include turf mode
Refer to your RZR 1000 owner's manual for oil requirements

Get your complete transmission today:

#SuperATV #GDP #BuiltForBattle

[traewilkins]

Should make a video of how to install gear reduction, reverse chain, and all yall's parts in one! Would be a huge help!

[denseleit]

Didn't need to take off as much as you did, but very informative .

[Truckman]

Just pulled my 16, xp4 1000 transmission, no need to remove hub assembly unless you got cv shaft issue, just leave castle nut and caliper all together, remove radius rods, sway bar link and shock bolts and trailing arm will pivot enough to get cv shaft out of transmission.

[justinmetheringham]

There's a tool that aligns the motor pto and tranny input before you tighten trans to motor

[vector]

make a HD version for the 900, 900S, 1000S, general. I believe they use the same trans with different prop shaft/secondary shaft ends. Anyone with a turf mode explosion or reverse chain failure would just buy your trans. Please make a CV axle cup/slide hammer tool. You would make serious $$.

[linearstream]

this transmition is awesome! any plans on making one for the Maverick X3?

[buildsd]

Is there a need for the clutch alignment tool for aligning the tranny to the engine or just watch the 10.5" dimension and call it good?

[denseleit]

Is that driveshaft stock or aftermarket?

[DylanFredrick-bf]

Is this about the same process on the general?

[rodzillamotorhead]

What prop shafts are in that machine? No u-joints?

[paulgarcia]

No wonder every time my buddies decide to do something to there Polaris transmission there’s always something not right. I keep telling them leave that stuff alone till it breaks. There’s so much to these to removing these transmissions there’s always something wrong when trying to put back together.

[michaelvoorhees]

Of course you skipped the part I needed as usual.... lost my lower passenger side trans to engine bolt and can't get the new one to catch that little plate back there for I think it's bent somehow. If I loosen the top bolt the bottom of the bracket comes in and the bolt will reach it but won't start.