Cutting baseboard around splayed (135°) bullnose corner-bead

In this video I show how to miter the cuts around a 135 degree angle bullnose corner-bead. This show what will happen when you use the 135 degree angle over using the 45 degree angle that you are supposed to use. I hope that this helps someone in my situation.

[azjohn]

This is likely the simplest, yet most complete explanation to baseboarding obtuse angles I’ve seen on the interweb. Thanks a bunch!

[ARomo]

This will be a timeless video! Thanks! Now I can have my weekend back!

[Craycola]

Having to do inside corners that are bullnosed and was destroying my brain but this reminded me what I was doing wrong. Thank you!

[mikichilcutt]

Thank you so much for this! I was confused about my 130.8 degree corner....

[yoyopinochio]

I've gone through so much scrap material trying to figure this out. So simple! Thanks so much

For those trying to measure angles, I bought a inside/outside angle finder which really helps when the walls aren't all the same

[mattcervantes]

You are awesome. I've been looking everywhere for this

[laurenscanga]

I've been struggling with how to solve this issue for a while now and just couldn't figure it out. You just saved me! Thank you!

[ianmorrison]

OMG! I have been looking forever for this solution. THANK YOU.
Perhaps a stupid question though; how do I accurately measure and cut the little middle piece? It's hard (and dangerous) to whittle down that little piece if it's too wide..

[CellarDoorHinge]

180 - 135 = 45
45/ 4 = 11.25
Always subtract the given angle from 180, then, divide by number of cuts.

[bh]

How do you determine the width of the peices, namely that little center peice?

[johnklein]

Very helpful video, it is simple and very understandable. How do you cut baseboard for the inside splayed (135 degree) corner as is formed in a Bay Window? Is it as simple as reversing the cut angle and using the same angle cuts? Do you have a video on that topic I can watch? Can you help me out here? Thank you in advance, I hope you see this request.

[mattmaccallum]

I could F'n kiss you right now! I've been going nuts all day until I found this. Thanks a billion! Life saver!

[johnbryan]

It worked but poorly explained. How did you come up with a 45 from a 135? That made no sense. I know it worked but I don't get it. Are you saying I ignore the 135° and just go off of a 45°. I still don't understand.

[johnbryan]

People's brains work differently. Why would you use the measurement of 135 if your just going to convert to a 45? If I understand correctly, the 135° makes no difference. All you are doing is taking a 3/4 corner and making it a quarter, and then reversing? I get that it works but I don't get how.

[johnbryan]

Omg this one was so much simpler. Sorry. I just wasn't getting it