Installing Transition Flashings on Metal Roofs

This video has information about how to flash the transition areas on your metal roof and why it is important to use flashing in transition areas.

[joycemyers]

Nice video. Helpful tips because I'm in the end stages of a metal roof over shingle on a big a$$house with crazy roof angles . Ive had to check out other buildings near me for guidance. Never done a metal roof before and im 59 yrs old

[joshuatoral]

We just bought a home that needed a new roof 10 years ago. I was very daunted about installing a roof because of the steep pitch and all the hood and valleys. But this metal roof playlist has been such a confidence builder for me!! Thank you so much. I will be tackling the project within the next month. I will report back when I’m all done. I’d love to send you a picture after the install

[cluebin]

Honestly the "wrong way" he showed looked a lot better than the correct way. I don't see why you couldn't make that work by having some foam closure strips behind where the two pieces meet or hit the back side of the seam with some foam sealant to fix the leak problem. Especially on a barn shed or something that isn't a house.

[clydedenby]

You all should make a flashing which has a bend to facilitate that transition but maintain the ridges and valleys of the panels.

[matthewcook]

Should you have first turned the sheets up on the lower sheets?

[steveperez]

I have an existing vertical metal shop wall. (Metal sheets run vertical) I’m going to attach a 2:12 lean to roof off the side. How do I properly flash the transition?

[victorialian]

GOOD WORK.we are roofing tile manufacture.Looking for ward to working with you

[jeffcritchlow]

What do you suggest for gambrel roof transition, same roll flashing?

[CharlesUFarley]

What’s stopping water from going up under the flashing ?

[hughlancaster]

On a hip cap, do you install the transition over the hip cap or under? For instance, I am installing metal on wrap around porch connected to a hip roof

[maijinprima]

I'm adding a deck onto our house and the house roof is asphalt shingles. Can i use this metal transition to go from the shingles to metal roofing?

[PedroRodriguez-hyty]

How about installing in the philippines do you have any pointers let me know thanks

[gmoneycash]

I am about to start on a roof for my 5x3 ft generator shed. It is lean to roof and hinged at the back( the highest part). I purchased a metal roof panel, cut it in half, drip edge and ridge cap for the back. I'm not sure if the ridge cap is the best to do in the back trying to cover the hinged part that could be exposed to water. What would be the best solution to cover the hinge with?

[davidtrang]

i need to know if we can install metal roof on flat roof please let me know thank you

[markknight]

What the heck is up with the heavy dent or dimples around the fasteners at 4:45 in this video?? Looks like hell !!!

[jamescole]

Nothing in the gap? More action less talk.

[chesterblack]

where can I buy the 21" roll flashing?

[berniestarzewski]

I find this a terrible type of flashing as it leaves the end totally open relying on some type of foam rubber to block the gaps. Scribed flashing panels are vastly superior but they are impossible to find at the big box stores. The profiled foam strips you do not even mention are impossible to align decently. If you dont use them you have an open path into the building for birds and bats not to mention wind. An incomplete and defective video.