Ford F250 Cruise Control Not Working | How to Diagnose and Repair Cruise Control Components

This video is about the Ford F250 cruise control not working. I will show you how to diagnose and repair cruise control components.
😎If this video has been helpful consider supporting us with a cup of coffee! 🙂

🛒PARTS LIST:

🛒TOOLS NEEDED:

➡️I am part of the Amazon affiliate program and get a small commission when purchases are made through the links provided.

🔺DISCLAIMER
The information provided by Valley Mobile Automotive (“we,” “us” or “our”) on this video is for general informational purposes and entertainment only and does not replace professional advice.
All information is provided in good faith; however, we make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability or completeness of any information on the video.
By working on your own vehicle, you take responsibility for the outcome.
Under no circumstance shall we have any liability to you for any loss or damage of any kind incurred as a result of the use or reliance on any information provided on this channel. Your reliance on any information on the videos on this channel is solely at your own risk.

[rjbrennanjr]

Well done video. Love that you go to the wiring diagram then back to the engine compartment to check each connection. I didn't understand the system well enough to troubleshoot my F250 cruise control - now I do. Thanks!

[Racerboy]

Thanks for taking the time and energy to show the entire CC circuit. This is the best video out there I have found.

[danielsmith]

Nice video, I was almost all the way through it when I realized it was for the gas truck and so of no use for diesel diagnoses.

[oonicello]

Best video I have seen on this subject to date. Thank you for pulling up the diagram and explaining and then demonstrating where it is physically located in the vehicle.

[BTimmer]

Thanks from Seattle for a great diagnosis video. I just fixed my 2000 F250 which had a leaking cutoff switch and a blown fuse in the harness by the switch. It was soaked in brake fluid.

[robertcheung]

Brother that is the most informative video on cruise control that I've seen, I just wish it applied to my 7.3 Powerstroke Thank You!

[lukewilson]

Thanks for the thorough diagnosis explanation!…everyone just talks about the pressure switch like they’re a ginus lol

[EngineerMikeF]

This is an excellent coverage of CC functions & parts including the wiring diagram usage & how to for the interactive parts that may contribute to CC failure

[jrande]

An awesome video and one of the best I have seen, so thank you!

[jerryhodges]

One thing not covered, but your vehicle didn’t have it I assume, is the clutch switch. But because of the diagram you shared I was able to trace my power issue back to the clutch switch.

[thebad]

That jumbo of zippy tide wiring harness is a recall to prevent fires because of that leaky brake switch

[anythingandeverything]

My haynes diagram didnt show that harness thanks for this video. Mine was one of those 2 amp fuses. I found put one fuse is before the pressure switch and the other is after the switch.

[iiviin]

this has been so helpful. i made it to the switch stage and it doesn't read a middle voltage, when I press the on button it reads BAT voltage, and the off reads a super small voltage. but unpressed it reads zero

[Trooper_]

The harness that’s on connecting to the master cylinder is there because the break sensor on it would leak then ground and it would heat an light the truck on fire

[victorarmas]

This was very informative, helped me understand and troubleshoot my cruise control thank you appreciate you

[briandahl]

Good job of explaining the whole system, keep it up for us DIY guys

[jyastic]

Great video and education. Good teacher...

[benreber]

This is an awesome video. Where did you get the wiring diagram from? I have the excursion with v10 2001 and it is the brake switch like yours that was the problem. It actually leaked into the plug and caught fire and tripped the fuse. I cut the switch off so it didn’t short out and replaced the fuse so now I need to replace it or make a long term solution so it doesn’t set the whole thing on fire. Bucket for me i was walking to it when I saw it blow a bunch of smoke and was able to check it.

[lcagee]

Excellent. Thanks. Is there also a fuse box that controls this? Under the dash? Under the hood? Mine went bad after I hooked up a faulty trailer wiring. Some lights went out. Replaced a light fuse but couldn’t find the cc fuses.

[JacenHorn]

I really like the way you explain things.