How to use Slime Tire Sealant

In this video I demonstrate how to properly install Slime Tire Sealant. I show proper installation procedure and explain how much Slime to use for your application.

If this video helped you, please help me and Like and Subscribe. Thanks!

[shannonbailey]

I ran an old tire for 25k more miles I love this stuff.

[HioffJames]

I put some on mine it’s been going strong for 3 days no problem.Usually it would be flat and it hasn’t lost any pressure at all.

[brucemartini]

great video, well done! to the point. On topic. No long intro. THANKS!👍😎

[WhiteoutMonster]

This "temporary solution" can last years lol

[piotrl.pawlak]

Nice video, but it seem like you missed a critical step of spinning the tire (driving a bit) to let the slime distribute.

[nkoch]

I run this in all mower and atv tires wether they have a problem or not

[chrisczarnik]

Will see how it goes on my Michelin tyre, its only a small leak where I have plugged the tyre after removing the screw out of it.

[badgerresistance]

Thanks for the video, after seeing all these steps using the slime. I decided to skip this step. I'll inflate the tire and drive to the tire shop.

[Dkk]

Hey Jason, I see the bottle says for off highway passenger vehicles. Has it worked just fine for your car ?

[lanieos]

wow someone smart who knows what people didnt know

[danmeyers]

Was reading it says “non highway vehicle.” Any issues from anyone using this for a highway vehicle?

[johnnydecola]

YOU FORGOT TO MENTION YOU NEED TO DRIVE VEHICLE

[johnnyelgegren]

Did you take the nail or screw out before?

[markkwasny]

The one-gallon size gives these formulas to calculate the amount needed : for low-speed tires (under 45 mph), width (inches) X height (inches) X 0.12 = Oz. required. In metric, width (cm) X height (cm) X 0.55 = mL required.
for high-speed tires (over 45 mph), width (inches) X height (inches) X 0.065 = Oz. required. In metric, width (cm) X height (cm) X 0.30 = mL required.

[bruceyung]

My bike has TPMS. Does it mess it up if I use this green blob?

[jacobhouston]

Good video but I wouldn't put it in tires that have tire pressure sensors in it. It will ruin it

[dirtyaznstyle]

You only need enough to fill the slow leak. I wouldn’t fill more than half a bottle lol

[AMC-eqjr]

Valve stems are permanently attached to the sensor stems and can not be removed.

[KT_inthe_ACT]

Your slime went right in. Mine has too much air pressure in the clear tube to squeeze it in.
What do I do

[alexandercspmx]

You obviously got paid by them to post this video, I was expecting to see an actual puncture but u only showed putting it in the tire so no proof here of it working/ just how to use it