Affordable Bridgeport / Knee Mill | Table Power Feed

Low Cost Knee Mill Table Power Feed..By Vevor
Installation Testing and Review

Link to this item: VEVOR X-Axis Power Feed

Coupon code: VVPRO
to save 5% off

Link to the Vevor Web Site:

0:00 Intro
1:01 Unboxing
4:32 Install Prep and Leadscrew Issue
7:58 Hardware Install
11:46 Shaft Key Issue
15:02 Gear Shimming
16:26 Custom Shim Needed
20:09 Final Install
22:45 Limit Switch
25:18 Test Run
29:56 Test Cut
32:24 Closing Remarks and Thoughts
****************************************************
Subscribe to the AYR Cave Shop:

Follow on Instagram:

Sorry I don’t do Facebook

#vevor #xpowerfeed #millpowerfeed

[MattysWorkshop]

Gday Dean, I have to say this has been the best powerfeed install/review video I've seen to date, your unit is much quieter then others I've seen when winding manually, the fly cutter finish was spot on, great job mate, thanks for sharing, Cheers

[railgap]

If your mill did not previously have a power table feed, these are great. IF your mill came with a bridgeport table feed, the spindle that the handle and/or drive mount to, is different, and you are in for some shop work to make an adapter.

[brucematthews]

Very timely. I've been putting off getting any sort of feed unit for a while. And just today I could have used one to let me do some long passes while doing other things than standing and turning the wheel. And yes, the Vevor units are among the lower cost options for me. So VERY timely. And a good video on the trials and tribulations too.