Dynamic EQ Sidechaining in FLStudio

How to setup a Dynamic EQ Sidechain in FLStudio

[gitsurfer]

Thankyou for this, concise and to the point without showing us a "full day in the life of" vlog first

[FlowersInHisHair]

Clear, concise and works perfectly. Thank you

[stuart.s.]

Having only just getting back into FL this is super helpful

[Wyklepheph]

Sometimes I'll use maximus as a frequency splitter, put the low/mid/high into their own mixer channels and then I sidechain the low/mid/high as needed. I like dynamic EQ but the parametric EQ bleeds while maximus will cut off all frequencies outside of the given range.

[SectorSevenSlumz]

This is cool but you're only make this band react to the whole signal. Whereas a dynamic Eq band will usually react to that specific frequency. You could put the peak controller in a patcher or another channel and limit the bandwidth that's feeding it to just that of the frequency you want to control on the other eq that's reacting. 👍

[Flux_One]

So do you only duck the fundamental frequency of the kick rather than all the low end and sub frequencies?

[strawberrycrxme]

Issue is, is that in FL 21 when you use fruity parametric EQ 2 for dynamic EQ sidechaining, it sounds terrible compared to FL 20.

[hellcatmusic]

So, I've been searching around. I know how to setup this techinque, but the issue I have is that I only want the start the original attack of the instrument to adjust the eq down while it's over a certain volume, like a real dynamic EQ does (think ozone dynamic eq or pro q3). How can I get that without using it with a short tail instrument like a kick you have in the video?

[realgemini]

I'm having a problem with this, when i want to use it more than once. It seems that it applies to the first Fruity peak/EQ somehow. Any solution?

[mattwilson]

i cant have my peak controller open at same time as my eq