[DIY] How to create your own Arduino uno board using only 3 components

** Correction i meant 22pf not uf. **
In this video i'll show you how to create a working arduino board using the ATMega328 chip, you will need:
(1) 16 Mhz Crystal
(2) 22pf Capacitor
(1) ATMega328 with arduino bootloader installed
(1) Arduino uno for programming

Steps:
1. Connect ATmega to breadboard.
2. Connect the crystal between pin number 9 and 10 of the ATmega (start counting from the side that contains the circle)
3. Connect one 22pf capacitor between pin 8 and 9
4. Connect one 22pf capacitor between pin 8 and 10
5. Connect pin 7 to + of the breadboard
6. Connect pin 8 to - of the breadboard

For programming, you can move the chip to arduino uno base and program it then move it back to breadboard, or you can use jumper wires and connect,
RX of arduino to pin 2
TX of arduino to pin 3
RESET ... to pin 1
GND ... to pin 8
VCC ... to pin 7
and make sure to remove ATMega328 from arduino board if there is any installed.

I hope you find this tutorial easy to understand, make sure to sub for more contents.

Tags:
arduino
atmega328
scratch
how
to
make
board
easy
tutorial
breadboard
DIY

[bocaderancho]

Ameiiii seu vídeo, seu conteúdo é incrível, ganhou mais um inscrito, vou continuar seguindo seus vídeos. Também sou criador de conteúdo, se puder verificar vou amar ter vc em meu canal. Deus te abençoe sempre 🙏