The BEST way to apply thermal paste?? 🤨 #shorts #gaming #gamer

You can Find most of what we do here!

#gaming #gamingpc #overkillgaming

[Frissdas]

I just paint mine. Perfect coverage every time.

[LastRightsTV]

I do the spread method like a real man

[ghost_fpv]

You guys are the definition of “he’s probably out there cheating” and i absolutely love it lol

[Jamham_]

I use X pattern with 4 small dots in the open areas

[thomaschirila]

Dude, put the cooler on with the acrylic sheet and then test them. That’ll be the most accurate, and you’ll see that the results will be a lot closer, if not the same

[mrsiege]

or u put a thin layer using a spreader. guranteed full covered 👌

[codydock]

If u tighten ur cooler down properly the pea size will spread over the whole chip.

[zica]

The best way is to spread yourself, perfect coverage granted every time

[shathaan]

So the x and very small dots in between should get you near 100% coverage right?

[thetutorialside]

If I bought the whole tube, I use the whole tube

[HairyScrambler]

When you fully tighten a cooler it does much more pressure than your hand. Even with a smaller amount than the pea just from tightening it’ll eventually cover the full IHS

[JBStudius]

Dot is fine for an IHS that is perfectly square (same length and width), the reason why you are not getting good coverage is because you can’t archive the same pressure just pressing down on it with your hands, as a cooler would be able to.
For intel’s oblong IHS a line from top to bottom will be fine.

[nerfmaniacOfficial]

I say that a X & dot combo would work really well

[uaDelicious]

Dont use a pattern. Just spred it by hand… patterns are for systemintegrtors in a hurry Business

[sbrowde]

This was a brilliant way of testing and giving us a direct visual result. Thank you. I’ve been a one line two dot man but will now convert to an x man.

[diogomiguel]

A square with a dot in the middle, absolute best for near 100% coverage with minimum spilling

[BRACIAKSERO]

Mine is X with dots on each side. I think it's the best option that resolve all the problems with other patterns

[YouBetterCallSaul]

I use kryonaut and spread it. Highly recommend thermal grizzly ❄️🤝🏼

[WilliamCamp-nx]

Heat also helps it spread. Pea size, don’t tighten it down where you can’t back screws off, run it for a hour stress testing and then tighten cpu cooler completely down. You’ll find this method gives you complete coverage every time. The only time you need to alter than pattern is with larger IHS cpus such as threadripper, epyc, xeons

[andrej_vu]

X with 4 little dots is 100percent coverage